Application viewpoint: in-depth introduction to tenda router settings

It is very helpful to know the specific steps for setting the tengda vro. Next we will explain in detail the detailed methods for setting the tengda vro. After a computer is added to the home, in order to connect two computers to the Internet at the same time, I purchased a Tenda router. The connection method is as follows: the Telephone Line bus access splitter, and one end of the router is connected to each phone at home, one end is connected to ADSL, and then the network cable from ADSL is connected to the WAN port of the router, so that the two computer network cables can be directly connected to the 1-4 ports of the router. The connection is still relatively simple, and the connection is completed soon.

Then, the tengda router sets up a broadband account so that the dial-up task is handed over to the vro. the login method of tengda vro is as follows: Open the browser and access: the default login account is admin. After login, the menu on the left is as follows: follow the prompts in "quick Settings" to fill in the broadband account step by step to complete the tengda router settings. In this case, you only need to select "Local Connection" property-General tab-double-click TCP/IP protocol-all the tabs displayed will automatically obtain the IP address and DNS server address), OK. Http: // 192.168.0.1

Now, the vro dial-up is complete, and the tengda vro settings can be set for accessing the computer after the computer is started. The two computers can access the Internet, but when I download the bt, I found that I can connect to the downloading user, but the speed is always 0. It turns out that the router port ing is required, return to the vro Management page and click "virtual server" to set port ing. The interface is as follows:

I am using the bitcomet software. Check its "options" to find the "listener port". This is the port occupied by bitcomet. Then fill in the box behind the "frequently-used port", followed by the Intranet IP address of your computer. You can choose "start"> "run"> "Enter ipconfig" to view the IP address, or directly use the maxthon browser, in the lower-right corner of the status bar, you can see what your ip address is. Because there are few computers here, although the tengda vro is set to automatically obtain the IP address, it will not change. Enter the settings, select TCP, and click Add.

In this way, the port ing is ready, and then click the DMZ host. Here, you can add one of your computers as the DMZ host. In fact, this computer is completely exposed to the Internet, therefore, downloading bt or anything will not be affected by the vro. This setting is not determined by yourself. Finally, click UPnP settings and select "enable ". In this way, all the vro settings are completed. Restart the vro (power-down or in the management menu: System Tool-restart the vro), restart the computer, and then enable bt. The download speed starts to increase, both computers can be downloaded. You can also set port ing for eMule on the virtual server. In this way, both computers can easily access the Internet, download BT or eMule.