BT4 Internet access settings (Wireless + wired)

Waiting for blog/

After BT4 is installed, wicd is provided by default, but it is not enabled by default. We can enable wicd for wireless networking.

1. enable wireless support

#:/Etc/init. d/wicd start

Then, find your company's wireless access point in the connection in the lower-right corner of the desktop, click Advanced Settings, enter the password, and click Connect.

#: Add the following settings to vim/etc/rc. local to enable the network management tool automatically upon startup.

# Added by www.waitalone.cn

/Etc/init. d/wicd start
 

2. Configure IP addresses for wired connections

#: Ifconfig eth0 192.168.0.2 netmask 255.255.255.0

#: Route add default gw 192.168.0.1

This setting is only valid for this setting.