Describes ten steps for vswitch password recovery

Steps for recovering the vswitch Password
⒈ Connects the console port of the vswitch to the terminal or the PC simulation terminal. Use a direct connection without Modem to connect the serial port of the PC to the console port of the switch.
⒉ First press the mode key on the switch panel, and then turn on the power.
⒊ Initialize flash.
> Flash_init
⒋ Rename the configuration file containing password.
> Rename flash: config. text flash: config. old
⒌ Start the vswitch.
> Boot
Secret enters the privileged mode.
> Enable
When the instance is started, the password is ignored.
# Rename flash: config. old flash: config. text
Copy the configuration file to the current system.
# Copy flash: config. text system: running-config
Modify the password.
# Configure terminal
# Enable secret
⒑ Save the configuration.
# Write