Fedora18 mount point/partition settings

Many friends sent an email asking about the issue of mounting the fedora18 installation time zone. Let me explain it in detail here. The first type is to reinstall fedora18 on an existing system. The first figure of the reserved/home partition must be selected. Otherwise, it is a complete disk partition if the entity is installed...
Many friends sent an email asking about the issue of mounting the fedora18 installation time zone. Let me explain it in detail here. First, reinstall fedora18 on an existing system to retain/home the first figure of the partition. Make sure to select the custom disk partition, otherwise, it would be a complete partition of a disk. if the entity is installed, it would be terrible. Click recycle space.
The second figure at www.2cto.com shows that a fedora18 system has been installed on the top. The/home partition should be retained. Select the/home partition and write/home at the Mount point to open the custom partition under the label. Note that you do not need to select the formatting option after reading it. However, we must select and format the swap partition.
Www.2cto.com. Note that there is a label under the mount point on the right. (if you reinstall fedora18 on a fedora 17 or 16 system, you should take a closer look at the content of this label. the content should be cleared when fedora18 is installed. Otherwise, an error will occur after you click "end partition". Note that this may be a BUG at the end of step 3. The Mount point has been set, but the system still reminds you to check for storage configuration errors. The yellow icon below reminds you to complete the content marked with this icon in the next step. Don't worry about it. let's click storage again. Go to Mount settings (do not adjust anything)
Run www.2cto.com and end the partition. check whether the yellow exclamation point exists! It disappears. Yes.