HP 360g5 centos7 installation problem, 360g5centos7
How to install HP 360g5 centos7 on the hp Server
I:The boot disk cannot recognize the hard disk.
1. Go to the installation disc and select centos -- Install Centos7 by pressing the up/down key (note that you cannot press Enter ),
2. Press the Tab key to configure the installation. The following words are displayed at the bottom of the screen:
3. Add the hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1, on the command line of the additional configuration ,:
II:Unable to boot after installation
Cause:CentOS boot progress bar Stuck at 100%
Firmware bug the bios has upted hw pmu resources
2.2 hard disk identification on startup Interface
The Wizard Page is displayed as follows:
As shown in:
Press e to enter the editing status.
Similarly, type the "hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1" parameter (refer to keep up with these parameters after quiet)
Press Ctrl + X to boot normally.
3. Hard Disk identification method for permanent startup
Enter the system as root, and edit/boot/grub2/grub. cfg in vi.
As shown in:
Find "linux17"
Press the End key to the End of the row.
Similarly, enter the "hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1" parameter to keep up with these parameters after quiet, or else it cannot be started.
[: Wq] Save and exit
2.3 restart Test
1 reboot
As shown in:
Press e to enter the editing status.
Similarly, type the "hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1" parameter.
Press Ctrl + X to boot normally.
Reference link:
Http://linux.it.net.cn/CentOS/CentosBug/2016/0514/21817.html
Http://www.linuxidc.com/Linux/2016-07/133089.htm