Router configuration beginner, practical collection

Ip nat pool-name available Internet address mask
Ip nat inside source list 1 pool-name overload

Interface s0
Ip address Mask
Ip nat outside
Interface e0
Ip address Mask
Ip nat inside
Access-list 1 permit example: 1.1.1.0 0.0.255 (1.1.1.X allowed)
Hello, everyone! I have some problems with this post. I am also a cainiao! I used the cisco2600 router for the first time. It seems that there are not many materials on the Internet! In addition, the information on www.net130.com is not very detailed! I can't quite understand it! My problem is: I connected the com serial port of the computer to the Console port of the route using a blue line, and then started windows2000 server. However, there was no response. The computer is enabled as usual. I went to its route and remote access settings to view the internal information of the routing interface. Both the loopback and the local connection have been found by the NIC device but cannot be reached. I also don't know how to set up cisco2600. I don't know how the following is done: (Please advise)
Ii. Command status

1. router>

The vro is in the USER command status. You can view the connection status of the vro and access other networks and hosts, but cannot view and change the vro settings.

2. router #

Enter enable at the router> prompt, and the vrouter enters the privileged command status router #. In this case, you can not only execute all user commands, but also view and change the vro settings.

3. router (config )#

Enter configure terminal at the router # prompt, and the prompt router (config) # appears. At this time, the vro is in the global setting state, and you can set the global parameters of the vrouter.

4. router (config-if) #; router (config-line) #; router (config-router )#;...

The vro is in the local setting state. You can set a local parameter of the vro.

5.>

The vro is in the RXBOOT status. Press ctrl-break within 60 seconds after the vro is started to enter this status. In this case, the vro cannot complete normal functions. You can only perform software upgrade and manual boot.
Refer to this configuration.

1. The intranet port IP address is defined below, and this port is specified as the NAT Intranet Port

Interface Ethernet0/0
Ip address 172.16.0.1 255.255.255.0.0
Ip nat inside

2. The Internet port IP address is defined below, and the port is specified as a NAT Port

Interface Serial0/0
Ip address 211.9.3.205 255.255.255.252
Ip nat outside

3. The NAT name is global-ip, and the value range is 61.24.78.25 -- 61.24.78.26.

Ip nat pool global-ip 61.24.78.25 61.24.78.26 netmask 255.255.255.252

4. specify the rules for NAT to use ACL 99 and enable address reuse (overload)
Ip nat inside source list 99 pool global-ip overload

5. A static route is defined below, specifying that all Internet addresses are switched to 211.9.3.206.
Ip route 0.0.0.0 0.0.0.0 211.9.3.206

6. the access control list (ACL) No. 99 is defined below, allowing all addresses in the Intranet to pass through
Access-list 99 permit 172.16.0.0 0.0.255.255

Note that the global configuration mode and port configuration mode are not mixed. Article entry: csh responsible editor: csh