Router to make switch settings tutorial

Management network friends may often encounter such a situation, only two routers, but only one network cable, then realize more than one computer at the same time need to switch to the Internet, then the extra router can do the switch? The answer is yes, but you need to set up the router. Here set the environment, here to share how to use the router as a switch.

Method One:

1, from a room in the network cable to connect the WAN Port B router, LAN port to connect the computer

2, enter the router configuration IE window input 192.168.0.1 username: admin password empty ENTER after the figure

3, set WAN port for dynamic IP address, LAN port set as default diagram

4, DHCP set as default diagram

5, at this time the computer automatically acquired the address as shown.

6, if DHCP disabled can surf the internet, try. Disable local connection and then enable local connection to yellow restricted or no connection, change IP address to Figure 6, and can be normal Internet.

Method 2:

1, wiring method unchanged, set WAN port for Figure 7, if DHCP shutdown computer set fixed IP

2, such as Method 1, open the DHCP computer does not have to set the IP address.

Method 3:

1, from a room in the network cable to connect the B router lan1 mouth lan2 port to connect the computer WAN empty (the router reset, all default settings)

2, into the router configuration interface, WAN mouth does not change, LAN mouth does not change, DHCP shutdown, at this point to view the IP address for Figure 8, see the Open Routing function of the modem has been assigned to the IP address, this time can be normal Internet.

Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join