Graphic Tutorial: ADSL Wireless Internet sharing settings

The following graphic Tutorial: ADSL Wireless Internet sharing settings make it easier for you to choose your preferred method. Many methods will make you suddenly enlightened. Next we will connect to the ADSL Modem and vro and set up a wireless router:

◆ Connect the telephone and ADSL Wireless Internet sharing settings and the divider according to the ADSLModem drawings, and then connect the network cable attached to the ADSL Modem to the WAN port of the Wireless Broadband Router; next, connect the desktop computer to any one of the four LAN interfaces on the wireless router.

◆ Install drivers and tool software for NICs on all other computers. After installation, enter the "Network Connection" setting (take WinXP as an example ), right-click the "local connection" (commonly referred to as "wireless network connection") used to access the Internet, and select "properties ", set "Internet Protocol attribute" to "automatically obtain IP Address" for ADSL Wireless Internet sharing.

◆ Start the device in sequence: ADSL Wireless Internet sharing settings, routers and computers, and determine the "Link/Act (connection)" in the "Power" and "Internet" columns on the front panel of the router) the indicator is green.

◆ Open Internet Browser IE on the desktop, enter "http: // 192.168.1.1" in the address bar, and press Enter. The Authentication Window appears, enter the default password according to the instructions.

◆ The ADSL Wireless Internet sharing setting page appears. The following is the configuration of the Wireless Broadband Router. The most important thing here is to set the "Internet" column to ensure that the router can establish a normal Internet connection. Select your own Internet access method from the "Configuration Type" drop-down menu (available from ISP). For example, use "PPPoE" to connect to the Internet, the setup program requires entering "User Name (User Name)", "Password (Internet Password)", and dialing settings.

Next, set the Wireless network. In the "Mode" column of "Wireless", set it based on the Wireless network card used, "Mixed" indicates that both 802.11b and 802.11G wireless standards are supported. "SSID" is the Service Set Identifier (Service Set flag), which can be Set according to your preferences.

"SSID Broadcast (SSID Broadcast)", which is set to "Enable" by default )". Through SSID broadcast, computers with wireless NICs can automatically receive and connect to the SSID within the signal coverage range. "WEP" is a data security encryption mode. We recommend that you set it to "Enable" for wireless transmission security ".

By clicking the "Edit WEP Setting" button, you can set a "Passphrase (Cipher language)" that you can easily remember when using ADSL Wireless Internet sharing. The device will automatically generate four "WEP keys" accordingly ", for wireless connection in the future, you only need to enter the secret language (you do not need to remember the complex WEP Key ). However, we can not set up WEP at the initial stage of the network to facilitate debugging.

 

ADSL Wireless Internet sharing settings

◆ After the Internet content is set, you can set more details (such as adjusting the subnet mask and setting higher security) by setting other labels on the interface if necessary ). After everything is okay, click the Apply button at the bottom of the Setting interface to save the settings and close the browser. Restart your computer.

At this point, the configuration of the Internet shared bandwidth is complete. Open your browser and enter a URL. The webpage content appears correctly. No matter you connect to a vro through a cable or by using a wireless network card, the computer connected to the vro can access the Internet normally, and the Internet connection is automatically completed as long as the vro starts, no dialing program is required on the computer.