HBase notes-problems during installation and startup

1. Run command execution failed when using HBase shell

For example: Perform status under the shell and fail.

Possible causes: The time gap between nodes is too large

Workaround adjust the time of the two nodes so that the two are consistent, here is a relatively stupid method

Use date to view the time of a node, and then modify the other node to keep the two, command:
Date-s "OCT 2015 17:10:00"

Other Workarounds: http://my.oschina.net/agony/blog/324478

2.HBase Web page is not open

Cause: The old version of the page address is master:60010, but after the 1.0 version of the port number is changed to 16030, the page address becomes master:16030
http://www.oschina.net/question/2350013_234170

Another workaround: http://www.zhihu.com/question/32085101 link inside the question below the comment

HBase notes-problems during installation and startup