How does the TP-LINK view the internet user's speed on the router?

If the network speed of a vro is slow during use, you must be sure to check whether a certain terminal can seize the network speed. You can view the network speed of each terminal on the vro management interface to provide a basis for you to determine the problem.

Use the vro management address (tplogin.cn or 192.168.1.1) in the browser to log on to the management interface.

Our vrouters have three different interface styles. The methods for viewing the network speed vary depending on different interfaces. Please refer to your vro interface for reference:

Old interface

Log on to the vro management page and clickSystem Tools>Traffic statistics,Enable traffic statistics Function. The real-time network speed of all terminals currently connected to the vro is displayed, as shown in the following figure:

Note:Some earlier vrouters can only display the traffic statistics, and the rate needs to be calculated by themselves (the value of the value to be refreshed once/the time to refresh = the average rate ).

To control the network speed of the terminal, set it in IP bandwidth control.

The new tplink interface is as follows:

 

 

Log on to the vro management page and clickConnection Device Management>Connected device (or master device)To view the real-time network speed of all the terminals currently connected to the vro, as shown in the following figure:

The new interface router supports the guest network. If the guest network function is enabled, the connection speed of the terminal connected to the guest signal must be in Connection Device Management > Visitor device.

You can directly set the network speed control on this page.

 

Vro

Log on to the vro management page and clickDevice Management>Master networkTo view the real-time network speed of all the terminals currently connected to the vro, as shown in the following figure:

Vro supports the guest network. If the guest network function is enabled, the network speed of the terminal connected to the guest signal must be Device Management > Visitor device.

You can click ManagementSet the network speed control.