How to use the computer correctly

How to use the computer correctly

1. High temperature

The computer ideal work temperature is 10-35 degrees, the temperature is too high or too low all bad. High temperature damage is mainly for temperature sensitive components, such as the CPU. CPU operating temperature must not exceed 80 degrees, otherwise it is very easy to burn the CPU, and it is best to install temperature alarm software. When using a computer in the summer, pay attention to indoor ventilation and cooling, so in the room with a computer, it is best to have air-conditioning.

2. Damp

The damage to the computer is also relatively large. The general relative humidity is more appropriate between 30%-80%. If the humidity is improper easy to cause short circuit. So when the air is too humid, the boot must be cautious. Also, be sure not to use the computer with your hands wet. Conversely, too dry is not good. Too dry and easy to produce static electricity, the same easy to computer melt finger to create harm.

3. Power supply

The power supply instability is actually a relatively large harm in the computer use process. Unstable voltage or instantaneous high current can easily cause more serious harm to the computer melt flow rate meter. The normal requirements of the computer for AC power are in the 220v,50hz, preferably with a good grounding system, preferably with a UPS.

4, dust

Because the computer chassis is not completely closed, and electrostatic adsorption dust, so dust is very easy to enter the computer. When the dust attaches to the surface of the integrated circuit, it will cause heat dissipation, melt index tester will cause short circuit when serious. Optical drive, floppy drive, monitor most afraid of the optical drive. If the head of the optical drive is adsorbed too much dust, it is easy to reduce the ability of reading disk. The dust is similar to the floppy drive damage and the optical drive. In the monitor, too much dust is apt to burn the monitor. such as keyboard, mouse and other accessories, are afraid of dust. Therefore, it is best to pay attention to the computer dust

5. Vibration and impact

Hard drive, optical drive, floppy drive are very afraid of impact, they are through the bald head to read the spinning disc. If the melting point tester is severely impacted, the lighter causes a scratch disc, and the heavy driver is completely screwed. No user of a computer would want such a thing to happen.

6. Static electricity

Static electricity is always the killer of precision circuit board. When the electrostatic accumulation to a certain extent, will produce high-voltage discharge in the local, easy to burn the circuit board. The easy way to protect is to give the computer a lot of discharge, and to touch the machine with metal objects is OK.

7. Radio

This killer is often overlooked, in fact, the melting point tester for the display of the harm is not small, for the motherboard also has interference effect. When the external radio signal is strong, the monitor's electromagnetic field will be seriously disturbed, if more times, the Monitor's normal working state will be affected. Therefore, it is best to avoid radio interference when using a computer.

The above questions, I hope you use the computer process attention, so as not to affect the computer life or cause computer failure.