How to swipe a vote in a micro-letter poll

1, open the micro-letter voting brush software Click to import Micro-signal, as shown in Figure 1:

2, in the micro-letter voting software on the vote to enter your vote link address Click to get voting information, as shown in Figure 2:

3. Continue to fill in the voting number on the micro-letter voting software, as shown in Figure 3:

4, note: Be sure to vote on the micro-letter voting software (tick after polling) options, as shown in Figure 4:

5, in the micro-letter voting software to fill out the vote on the number of votes, if you need to replace the IP on the hook, do not need not to hit the hook, as shown in Figure 5:

6, click on the micro-letter vote on the software "confirmation" to start execution, to suspend the voting, click "Cancel" to suspend the termination, as shown in Figure 6:

Our micro-letter voting software can help you to handle the number of micro-vote you want without the micro-letter vote, I hope that the small series of the above introduction of the micro-letter vote Brush reader to use the tutorial can help everyone!