How to use the MediaCoder audio and video Transcoding Express to carry on the sound transfer code

1, the first need to configure parameters, we can configure through the Setup Wizard (General software Open will open the Setup Wizard, you can also open the Setup Wizard in the following way)

2, click the wizard button, and then click the Transcoding Configuration Wizard, you can open the Settings Wizard

3, suggest everyone before setting, bar "restore all set to default value" This option on the hook, and then click Next

4, this is the hardware acceleration settings, in general, to enable hardware acceleration, to have the appropriate hardware, and only for video, because we are in the audio conversion, check "Use CPU code" can, and then click Next

5, select "Audio file"

6, here is the most important step, choose the file you want to convert to what format, in general, choose a format on the left, the right will appear on the corresponding format of the specific settings, we convert here to MP3 format, set the code rate mode for VBR, the quality set to the highest. (If you want to specify the code rate for transcoding, you can choose CBR or ABR.) ) Click to enter the next

7, the audio sampling rate generally do not need to adjust, directly click "No", into the next step

8, channel settings usually do not need to be adjusted, next, and then you can see

Such a hint, click the hint below the

"Press this Start" button to start mediacoder the audio transcoding according to the set parameters

9, in fact, there are more efficient way to set up, is in the program under the main interface settings inside, click on the left of the audio, and then press the settings below, at the same time, rate mode, code rate, etc. can be set on the right, we have just entered the Setup wizard opened, should be to avoid the user face a bunch of parameters, Do not know where to start and design, familiar with the software, you can directly start setting, do not have to go through the Setup wizard.

10, the next step is to add the file or folder you want to convert, click the Add button above, select "Add File" or "Add Folder" as needed

11, but also to set the output folder, that is, you convert the file to save to where

Click on the upper right of the program arrow pointing to the button, you can select the path to output, set up, click the Start button (the picture can also see this button), you can begin to convert.

In addition, if you want to quickly open your own set of output folder, try the converted file is what, click on the "Open" button, you can immediately open the output folder you set, and then find your conversion file, this design is very convenient.