Learn more about Cisco Switch Basic command Rollup

Pen name is also large, commonly known as the small game

Recently work has become a little different, received their own network engineers exam is almost 2 doors are nearly point on the heart has a lot of depressed and lost, may be doomed to let me have a good reflection on it, for this today self-study review of the past Cisco Cisco Simple Foundation.

Cisco commands and H3C are far apart, recalling that Cisco is very far away from the past, moving fingers simply record their thoughts at the moment.

Cisco commands (written in Cisco emulator software):

Enable access to privileged mode

Config terminal enter System configuration mode

Hostname sw-2f#desk Switch name (generally I use XX equipment-floor-use)

Enable password Aa123456 configuration mode password (clear text)

Secret password Aa123456 (ciphertext)

Line vty 0 4 (set up a virtual terminal to connect to 5 accounts)

Login (remote connection into mode account)

Password Aa123123 (remote connection entry mode password)

Interface fastethernet 0/0/1 (default port belongs to VLAN 1, no need to enter VLAN 1 to set IP)

IP address 192.168.1.1 255.255.255.0 VLAN 1 switch remote access IP addresses

No shut down activation port

VLAN 10 Create VLAN 10

Interface VLAN 10 into virtual VLAN

Switchport range fastethernet 0/0/2-8 (port 2-8 belongs to VLAN 10)

Exit exits

Empathy

Interface FastEthernet 0/0/2

IP address 192.168.10.1 255.255.255.0

No shut down activation port

Exit

VLAN 20

Interface VLAN 20

Switchport Access FastEthernet 0/0/24

Exit

Interface FastEthernet 0/0/24

IP address 192.168.20.1 255.255.255.0

No shut down

Exit

Show Running-config View Run Configuration

Copy running-config Save configuration

The connection configuration between switches can be access (connecting devices are usually terminals and routers), trunk (trunking mode is typically connected to an interactive device)

Terminal Remote Access switch operation:

Host configuration: ip:192.168.1.2 (must be in the same LAN segment as VLAN 1)

Mask: 255.255.255.0

Gateway: 192.168.1.1 (VLAN 1 IP is gateway)

DNS: Auto Get

Enter the Switch interface:

First open the cmd command to run the box, enter "Telnet 192.168.1.1", password "Aa123456", password "Aa123123", followed by "Ping the Switch IP address", if you can interworking how to configure the correct.

This article from "7732617" blog, declined reprint!

Learn more about Cisco Switch Basic command Rollup