Maya made the burning fuse

This tutorial will guide us through the creation of a burning fuse.

1. Create a nurbs circle and a curve. parameters, such as diagram settings.

2, in the created surface input project, there are two secondary curves, which are used to regulate the formation of local surfaces. And all have two values to tune. Subcurve1 is associated with the contour line. Subcurve2 associated with the path.

3, this is the motion path curve, the secondary curve sets the min value=0 in 0 frames, and sets the set key.

4, this is the motion path curve, the secondary curve sets the min value=0.92 in 100 frames, and sets the set key.

5, at the 1th frame Select the extrusion surface CV control point, as shown in the figure.