Methods and techniques of cutting out objects in AutoCAD

What methods and techniques should we use if we want to trim an object outside a range of AutoCAD drawings?

As shown, to the right figure part of the circle outside the line to cut, the general method is to select the cutting edge, and then select the segment to be trimmed can, in fact, AutoCAD also has a relatively simple way.

Click to enlarge

1. According to the general execution of the crop command, select the clipping boundary, carriage return confirmation.

2. Enter "F" (ie fence) when prompted to select the segment element to be cropped, carriage return confirmation.

3. At the tip: The Fence point draws a continuous rubber line that intersects the segment you want to crop, and the carriage return confirms it.

Note: 1. The rubber band line does not need to close;

2. The rubber band line and to crop line overlap, then cut the next part, this is very important.

Additional methods are attached:

In version 2006/2007, you don't have to press f anymore, you can select all the lines you don't want.

AutoCAD fully installed after the Express menu has a extend Trim tool, very easy to use, we can try.