Notebook hard disk has the phenomenon of suspended animation how to do?

Notebook hard disk has the phenomenon of suspended animation how to do? The specific solution is as follows:

The computer hard disk occasionally sends out the card sound, then will accompany several seconds and freezes the same phenomenon, after a few seconds will be good. What's going on, is there a problem with the hard drive?

Two reasons, the first may be your system problems, the system or application software caused by the wrong data read the hard drive in the blink of an instant high speed repeatedly read and write operation will produce a lot of noise. The second is the problem of the hard disk itself, we can test the software to do a test.

HD Tune main interface

1: Benchmark (disk performance) test

When you start the software, you will first show the model and current temperature of the hard drive, the default display is the disk basic test interface, in which users can click the "Start" button, the hard disk read and write performance testing, mainly including reading and writing data transmission rate, storage time and CPU occupancy, etc. and, The entire test process lasts a few minutes and the user needs to wait patiently.

Note: You want users to use caution because of the risk of writing tests.

2: Disk Health Diagnostics

In the health picture, HD Tune also has a full range of physical examination of the disk, involving all aspects of the performance parameters of the disk, and there are detailed numerical display, such as read error rate, seek error rate, write error rate, temperature, power time and so on; may be a lot of performance parameters users are not very clear, But it can give users a sense of the true state of the hard drive running.

3: Error Scan test

In the error-scanning test page, the user can click the "Start" button to detect whether the disk has a damaged sector. However, the user should note that if the "Quick Scan" option is not checked, the running time will be longer, so users are advised to check this option to quickly detect.

4:aam settings

AAM's English is all called Automatic acoustic Management, translated into Chinese meaning-automatic sound management. The noise of hard disk is mostly caused by the vibration of itself and the continuous operation of the head, in other words, the higher the speed of the hard disk in the same environment, the greater the noise. This function is actually to adjust the noise when the hard drive is running. But be aware that not all computers can turn on this feature, and if this feature is turned on, adjusting the settings to low noise may reduce the performance of the hard drive.

Download Diskgenius for the detection of repair, the following steps. Open the direct interface after the program, note that you must make sure that the U disk has been recognized in my computer. If the drive is not shown in the system, it is a different situation.

In the case of recognition of the hard drive, it is the following to select the drive letter of the hard disk

Select the hard drive letter, select the "Hard Drive" menu to choose "Bad track detection and repair"

The following interface appears, and you can still select a different letter. The bottom left corner is "Start detection" and "try to repair"

Detection will appear after the report, I have seen is not bad, if prompted a bad way then again select "Try to repair" that is