Oracle11gR2: Node Connectivity check failed solution

Source: Internet
Author: User

Oracle11gR2: Node Connectivity check failed solution

The prompt "Node connectivity check failed" is displayed during the installation check on the oracle11GR2 GUI, as shown in:





There are two main reasons for this problem:

1./etc/hosts not properly configured
2. Firewall is not disabled in Linux.

However, my firewall is disabled, and the hosts file is also configured.

Run the runcluvfy tool to check whether:

Grid @ node74:/home/software/linux_11gR2/grid>./runcluvfy. sh stage-post hwos-n node74, node76-verbose

Padding post-checks for hardware and operating system setup


Checking node reachability...
Check: Node reachability from node "node74"
Destination Node Reachable?
------------------------------------------------------------
Node74 yes
Node76 yes
Result: Node reachability check passed from node "node74"

Checking user equivalence...
Check: User equivalence for user "grid"
Node Name Comment
------------------------------------------------------------
Node76 passed
Node74 passed
Result: User equivalence check passed for user "grid"

Checking node connectivity...
Checking hosts config file...
Node Name Status Comment
------------------------------------------------------------
Node76 passed
Node74 passed

Verification of the hosts config file successful

Interface information for node "node76"
Name IP Address Subnet Gateway Def. Gateway HW Address MTU
-----------------------------------------------------------------------------------------
Eth0 172.16.54.76 172.16.52.0 0.0.0.0 172.16.52.254 B4: 99: BA: BC: 31: 4A 1500
Eth0 172.16.54.176 172.16.52.0 0.0.0.0 172.16.52.254 B4: 99: BA: BC: 31: 4A 1500
Eth1 10.10.10.2 10.10.10.0 0.0.0.0 172.16.52.254 B4: 99: BA: BC: 31: 4C 1500
Eth2 255.255.20.2 255.255.20.0 0.0.0.0 172.16.52.254 B4: 99: BA: BC: 31: 4E 1500

Interface information for node "node74"
Name IP Address Subnet Gateway Def. Gateway HW Address MTU
-----------------------------------------------------------------------------------------
Eth0 172.16.54.74 172.16.52.0 0.0.0.0 172.16.52.254 98: 4B: E1: 04: C7: B4 1500
Eth0 172.16.54.174 172.16.52.0 0.0.0.0 172.16.52.254 98: 4B: E1: 04: C7: B4 1500
Eth0 172.16.54.175 172.16.52.0 0.0.0.0 172.16.52.254 98: 4B: E1: 04: C7: B4 1500
Eth1 10.10.10.1 10.10.10.0 0.0.0.0 172.16.52.254 98: 4B: E1: 04: C7: B6 1500
Eth2 255.255.20.1 255.255.20.0 0.0.0.0 172.16.52.254 98: 4B: E1: 04: C7: B8 1500

Check: Node connectivity of subnet "172.16.52.0"
Source Destination Connected?
----------------------------------------------------------------------------
Node76: eth0 node76: eth0 yes
Node76: eth0 node74: eth0 yes
Node76: eth0 node74: eth0 yes
Node76: eth0 node74: eth0 yes
Node76: eth0 node74: eth0 yes
Node76: eth0 node74: eth0 yes
Node76: eth0 node74: eth0 yes
Node74: eth0 node74: eth0 yes
Node74: eth0 node74: eth0 yes
Node74: eth0 node74: eth0 yes
Result: Node connectivity passed for subnet "172.16.52.0" with node (s) node76, node74

Check: TCP connectivity of subnet "172.16.52.0"
Source Destination Connected?
----------------------------------------------------------------------------
Node74: 172.16.54.74 node76: 172.16.54.76 passed
Node74: 172.16.54.74 node76: 172.16.54.176 passed
Node74: 172.16.54.74 node74: 172.16.54.174 passed
Node74: 172.16.54.74 node74: 172.16.54.175 passed
Result: TCP connectivity check passed for subnet "172.16.52.0"

Check: Node connectivity of subnet "10.10.10.0"
Source Destination Connected?
----------------------------------------------------------------------------
Node76: eth1 node74: eth1 yes
Result: Node connectivity passed for subnet "10.10.10.0" with node (s) node76, node74

Check: TCP connectivity of subnet "10.10.10.0"
Source Destination Connected?
----------------------------------------------------------------------------
Node74: 10.10.10.1 node76: 10.10.10.2 passed
Result: TCP connectivity check passed for subnet "10.10.10.0"

Check: Node connectivity of subnet "zookeeper 20.0"

WARNING:
Make sure IP address "your region 20.1" is up and is a valid IP address on node "node74"
Source Destination Connected?
----------------------------------------------------------------------------
Node76: eth2 node74: eth2 no
Result: Node connectivity failed for subnet "zookeeper 20.0"

Check: TCP connectivity of subnet "20171000020.0"
Source Destination Connected?
----------------------------------------------------------------------------
Node74: zookeeper 20.1 node76: zookeeper 20.2 failed ------ Note: if one of the two nodes is configured with an IP address in the same network segment but is not connected, node connectivity check fails.
Result: TCP connectivity check failed for subnet "commandid 20.0"

Interfaces found on subnet "172.16.52.0" that are likely candidates for VIP are:
Node76 eth0: 172.16.54.76 eth0: 172.16.54.176
Node74 eth0: 172.16.54.74 eth0: 172.16.54.174 eth0: 172.16.54.175

Interfaces found on subnet "10.10.10.0" that are likely candidates for a private interconnect are:
Node76 eth1: 10.10.10.2
Node74 eth1: 10.10.10.1

Result: Node connectivity check failed

Checking for multiple users with UID value 0
Result: Check for multiple users with UID value 0 passed

Post-check for hardware and operating system setup was unsuccessful on all the nodes.

It turns out that the two nodes have a pair of NICs configured with the IP address of the CIDR block, but in fact the two NICs are not connected, resulting in node connectivity check failure.

Check: TCP connectivity of subnet "20171000020.0"
Source Destination Connected?
----------------------------------------------------------------------------
Node74: fail 201720.1 node76: fail 201720.2 failed


The solution is either to connect two NICs, or to change to different network segments, or simply disable these two NICs.

I disabled these two NICs and re-run the installation check.

Related Article

Contact Us

The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion; products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the content of the page makes you feel confusing, please write us an email, we will handle the problem within 5 days after receiving your email.

If you find any instances of plagiarism from the community, please send an email to: info-contact@alibabacloud.com and provide relevant evidence. A staff member will contact you within 5 working days.

A Free Trial That Lets You Build Big!

Start building with 50+ products and up to 12 months usage for Elastic Compute Service

  • Sales Support

    1 on 1 presale consultation

  • After-Sales Support

    24/7 Technical Support 6 Free Tickets per Quarter Faster Response

  • Alibaba Cloud offers highly flexible support services tailored to meet your exact needs.