PS Make stamp effect

Final effect Diagram

1, first open the image you want to make a stamp. Then select the parts that you want to use as a stamp, and then probably define a slightly larger area, and these basic composition tasks have to be done in mind. Here we randomly pick a picture and use Photoshop to open the image.

2, the first thing to do is to convert the background layer to the normal layer, this is to facilitate some of the later work. Double-click on the layer of the image we open, click OK on the pop-up dialog, and he changes from the background layer to the normal layer.
3, below we will enter the process of making hole, here we first set the rubber tool. In the rubber's Brush bar, select the brush tip shape, set the diameter, set the diameter here is what we want to make the hole diameter, diameter and the size of the image to be selected is a certain proportion, too large or too small will make the whole image of the real sense of decline. How big can you try to see that the diameter can achieve better visual effects. Here we use a rubber diameter of 10 pixels. Then set the hardness. This is set to 100% because the effect does not need to be dimmed. The last is the key point, the choice of spacing is 150%, this then produces the effect of the following figure. We can see that our tool for making holes has already appeared.

4, then use our eraser in the position of the top left corner, hold down the SHIFT key, horizontal or vertical to the end of the mouse drag, make the first row of the teeth hole. Then put the mouse circle exactly in the circle at the end of the first circle. Be sure to align, or you'll break the last hole. Also hold down SHIFT and make the second edge. Then make a third, fourth article in turn. Of course, if the holes in these steps are strictly aligned. The fourth tooth hole can coincide exactly. The thing to pay attention to here is to make the tooth hole strictly aligned.

Category:

• PS Getting Started Tutorial