Set VLAN for AVAYA_CAJUN vswitch

The first step in configuring VLAN 1 in an AVAYA_CAJUN vswitch to set a VLAN is to first create a VLAN. In an AVAYA vswitch, you must first create a vlan id and name. In fact, the name is only used to help identify VLANs, the switch identifies different VLANs by ID. After creating a VLAN, you can specify a port as the corresponding VLAN. The procedure is as follows: Step 1: set vlan <VLAN_id> [name <VLAN-name>} Step 2: set port vlan <VLAN_id> <module number>/<port number> Configuration instance: P130-1 (super) # set vlan 2 name class1 VLAN id 2, vlan-name class1 created. p130-1 (super) # set port vlan 2 1/11 VLAN 2 modified. VLAN Mod/Ports ---- --------------------------- 2 1/11 to view VLAN configuration use the following command www.2cto.com show vlan [<vlan-id> | name <vlan-name>] P130-1 (super) # show vlan vlan id Vlan-name --------- ---------------------------- 1 V12 class1 clear VLAN use clear vlan [VLAN_num] 2 set the port binding mode. There are two port binding modes: static and dynamic. Static mode is a common mode. When a port belongs to only one VLAN, static mode is used. Dynamic mode is used in combination with VLAN tags. Set port vlan-binding-mode [port_list] [value] Value static-use the specified VLANbind-to-configured-port to support all VLANs configured by the switch, in combination with 802.1Q, 3 sets the VLAN frame flag www.2cto.com AVAYA low-end switch to support the standard 802.1Q protocol. The high-end P580R/P882R also supports cisco isl and 3COM VLAN tags. Set trunk <module number>/<port number> {off | dot1q} P130-1 # set trunk 1/19dot1qDot1Q VLAN tagging set on port 1/19. p130-1 # set trunk 1/19 offNo VLAN tagging set on port 1/19. 4. Specify multiple VLANs statically on a port. This function is mainly used when the server provides services for the specified VLAN. Configure the IP addresses of different network segments on the NIC of the server. Use set port static-vlan <module number>/<port number> [vlan num] P130-1 (super) # set port static-vlan 1/11 3 VLAN 3 is bound to port 1/11P130-1 (super) # set port static-vlan 1/11 4 VLAN 4 is bound to port 1/11 if you want to clear the specified static VLAN, use clear port static-vlan <module ID>/<port number> [vlan num]