Several Basic settings after installing the router OS

Terminal ANSI detected, using single line input mode
[Admin @ mikrotik]> Interface View NICs
[Admin @ mikrotik] interface> PR Existing NICs
Flags: X-disabled, D-dynamic, R-running
# Name type RX-RATE TX-RATE MTU
0 r ether1 ether 0 0 1500
1 pppoe-server pppoe-in 0 0
[Admin @ mikrotik] interface> set 0 name = LAN Set Nic name
[Admin @ mikrotik] interface> PR
Flags: X-disabled, D-dynamic, R-running
# Name type RX-RATE TX-RATE MTU
0 r LAN ether 0 0 1500
1 pppoe-server pppoe-in 0 0
[Admin @ mikrotik] interface>/
[Admin @ mikrotik]> IP Address NIC address settings
[Admin @ mikrotik] IP address> PR
Flags: X-disabled, I-invalid, D-dynamic
# Address network broadcast Interface
0; added by setup
192.168.233.233/24 192.168.233.0 192.168.233.255 LAN
Admin @ mikrotik] IP address> Add address = 192.168.0.1 netmask = 255.255.255.0 interface = LAN The specific setting command can simplify writing your own research.
No such argument (netmast)
[Admin @ mikrotik] IP address> PR
Flags: X-disabled, I-invalid, D-dynamic
# Address network broadcast Interface
0; added by setup
192.168.233.233/24 192.168.233.0 192.168.233.255 LAN
1 192.168.0.1/24 192.168.0.0 192.168.0.255 LAN
[Admin @ mikrotik] IP address>
In this step, the most basic settings have been completed. Of course, there is a simpler method, that is, directly setup.
However, we still need to learn how to use basic commands. Right?
Next, enter the IP address you set in the IE browser and download a winbox. Then, you can see your own capabilities. If you don't write much about it, can you refine it?
Go to: http://www.router.net.cn/softrouter/12249.html