Solid-State HDD AHCI is disabled how to do?

AHCI, the full name Advanced host Controller Interface, the Advanced Host controller interface, is better suited to the SSD communication protocol than the old IDE virtual mode. What if you use some hard drive detection software to indicate that SSD is disabled? The easiest way to do this is to try to turn on AHCI mode.

Turn on the hard drive AHCI mode, you need to enter the computer BIOS settings, the specific way is to restart the computer, and then the boot has been pressed "Del key" into.

After entering the motherboard BIOS setup interface, and then in the Advanced (Advanced) option, find the SATA interface mode settings interface, then you can see the SATA mode IDE, AHCI, RAID three, select AHCI mode, and then press F10 Save exit, as shown in the following figure.

"Note" Different computers enter the BIOS method and open AHCI method may be different, but the general idea is similar, we need to learn to extrapolate. In addition, some older motherboards do not support AHCI mode, and usually this old motherboard does not have a SATA3.0 interface, and it is not necessary to use solid-state drives.