The method of fiber connecting wireless router

First step: The hardware part of the connection. With a network cable will be any one of the cat's network port and wireless router WLAN port connection, the other computers in the LAN need to be wired to the Internet, you can through the network cable will be the computer network with the wireless router LAN port can be connected.

Step two: Reset the IP address of the router. Open the browser on the computer connected to the router, enter the router-side control address http://192.168.1.1 and return, locate the "Network settings" → "LAN port settings on the open page, reset the router's IP to" 192.168.2.1 "and click" Save " Complete the IP address settings for the router.

Step three: In the open page, find "network settings" → "Wan port settings", reset the router's WAN connection type to PPPoE, then enter the Internet account and password, tick "On demand" mode, and click "Save" to complete the WAN settings for the router.

Step Fourth: Find the "DHCP server" → "DHCP service" in the open page, select Enable DHCP server, set address pool start address to "192.168.2.100", address pool End address set to "192.168.2.199", click "Save" Complete the DHCP settings setting for the router.

Step Fifth: Finally configure each device connected to the wireless router. Configure its IP address access is automatically obtained.

Above is the fiber-optic connection wireless Router Five steps, the optical fiber connection and the telephone line connection actually is the medium different, the connection method is not special, needs the special attention is protects the good fiber optic line, is weaker than the telephone line, therefore must be careful.