Tp-link Cloud Router Visitors how to set up a wireless network

Tp-link Cloud Router guest wireless network setup reason

A guest wireless network is a wireless network that is provided to visitors, as opposed to a wireless signal that you use yourself. Guest wireless networks are available for normal access, but can be restricted by multiple permissions. Have a visitor network, no longer need not to inform wireless password and embarrassed, also save visitors occupy large traffic bandwidth or network security and worry.

Shortcut settings method. After the login interface, on the left side of the network state interface, open and set up. The following steps are specific to this procedure.

Tp-link Cloud Router guest wireless network settings first step, enter the page

Login Router Management interface, click Application Management, enter the Application Center, the following figure.

Find the Visitor network and click Enter.

Tp-link Cloud Router guest wireless network setup step two, guest wireless parameter settings

1, set the guest network parameters

Please follow the instructions set below.

Attention. The internet speed and opening hours here are for all clients of the entire guest network.

2. Observe guest status

In the equipment management, click on the visitor device, can be for the visitor terminal speed limit, Internet access restrictions and so on.

At this point, the guest wireless network setup is complete.

Tp-link Cloud Router Set administrative permissions first step, enter the Settings page

Login Router management interface, click Device Management, enter the management Settings page, as shown below.

To locate the Administrator qualification, click Enter.

Tp-link Cloud Router Set administrative permissions Step two, set administrator credentials

1. Set Management type

Select the corresponding administrator identity qualification type, as follows.

Attention. You can also click Add MAC address manually.

2, select the host with administrative authority

Select the host you are prepared to give administrative privileges

3. Save Settings

When the settings are complete, click Save.

At this point, the Administrator identity qualification setting is complete.