TP-LINK router default (factory, original) login username password tutorial

Note:In this document, the default, factory, original, and initial meanings are the same. The username and account are synonyms.

If you have just bought a vro or restored the factory settings of the vro, you need to log on to the vro management interface and perform related settings. You must enter the user name and password to ensure the security of your device and network.

Due to different vro software, the user name and password required for logon are different. Be sure to compare them with your vro:

[1]Current maximum: No logon Username. Set the administrator password.

For initial settings, you must set 6 ~ The 15-bit administrator password will be used to log on to the interface later. There is no default password. Be sure to see clearly,This page allows you to set your own password. The interface style is as follows:

TP-LINKTraditional interface style

TP-LINKNew interface style

If you only need to enter the password, it indicates it is not the factory status. Reset the vro and log on again.

[2]Earlier vrouters: The default logon username and password are allAdmin

By default, logons are performed in the factory status. You must enter admin in the user name and admin in the password (lowercase letters ). The interface style is as follows:

If an error is prompted, the password may have been changed (that is, it is not in the factory status). Reset the vro (see the end of the article.

[3] A few portable routers : No logon Username. The default password is Admin .

Such as TL-WR702N, TL-WR710N and other portable mini router, the default login password is admin, the interface is as follows:

If an error is prompted, the password may have been changed (that is, it is not in the factory status). Please reset the vro.

Vro reset method

Find the RESET button or RESET hole of the vro, as shown in the following figure:

 

When the vro is powered on, press and holdRESETKey5More than secondsWhen the indicator light is on (some routers are system indicators flashing at the same time), the reset is successful. (Hold down the RESET hole with a clip needle and other sharp objects ).