Tp-link Wireless router How to set fixed IP address to the Internet

Tp-link Wireless Router to set fixed IP address for Internet

Warm tip: Please judge your own way of surfing the internet, in the end is not static IP network type; If you are not able to judge yourself by the introduction of the appeal, you can call your broadband operator and figure out the router again.

Step one, set up the computer IP address

Before setting up Tp-link tl-wdr5600 wireless router to surf the internet, you need to set the IP address of the computer to automatically obtain (dynamic IP).

Step two, tl-wdr5600 router installation

1, Optical brazing: Please prepare 2 network cable, a network cable used to connect the light cat and tl-wdr5600 Router WAN interface; Another network cable is used to connect any LAN (1/2/3/4) interface and computer on the tl-wdr5600 router.

2, network cable households: Please prepare 1 network cable, first the broadband operator provided by the household network cable inserted in the WAN interface of the tl-wdr5600 router, and then the network of their own to connect the computer, the other end connected to the tl-wdr5600 router on any one LAN (1/2/3/4) interface.

Pay attention to the problem

(1), in accordance with the way of appeal to complete the installation of tl-wdr5600 router, the computer can not be online for the time being, when the tl-wdr5600 router completes the Internet setting, the computer automatically can access the Internet, do not need to use the computer "broadband connection" to dial the Internet.

(2), a lot of novice users, often asked me this connection, the computer has no network, how to set up the router? When setting up a router, you do not need to have a network, as long as the LAN connection between the computer and the router can be set up, please understand the novice users,

(2) After the installation of the TL-WDR5600 wireless router is successful, the SYS indicator light on the device flashes and the WAN interface is often lit or blinking, and the port connected to the computer in 1/2/3/4 is often bright or blinking. If the corresponding LEDs are not lit or blinking, check to see if the power supply is plugged in, the connection is correct, and the network cable is wrong.

Step three, tl-wdr5600 fixed IP internet settings

1. Enter in the browser: tplogin.cn and press the ENTER key on the keyboard.

2, in the pop-up dialog box "set the login password."

Warm tip: Please keep in mind that you set the "Login password", the next login to the settings interface, you need to enter just set the "login password" to be able to log in; If you forget to set the login password, the only solution is to put the tl-wdr5600 router back to the factory settings.

3, into the management interface, the router will automatically detect the way the Internet. If the Internet is detected as a fixed IP address, continue to the next setting.

4, fill in the operator assigned IP address, subnet mask, gateway and DNS server address, and then click the "arrow."

5, Wireless settings: In the wireless name set the wireless network name, in the wireless password set not less than 8-bit wireless password. If you check the same 2.4G wireless password, 2.4G is the same as the 5G wireless password.

Pay attention to the problem

(1), wireless name, please do not use Chinese, because some wireless devices do not support Chinese, there will be no signal to search the situation.

(2), wireless password, please use the combination of uppercase and lowercase letters, numbers and symbols, and the length must not be less than 8 bits.

6, click "Confirm", complete the setup.

7, the Setup Wizard completes, enters the router management main interface. Observe the status bar, and if "Internet settings" appear as shown in the picture on the right, the network connection is successful. At this point the computer only needs to connect the router LAN port or wireless network, no need to set up the Internet.