Tplink router signal amplifier how to set

　　 tplink router signal amplifier setting method

Step one, preparatory work

First, please clear the need to be relayed (amplification) of the wireless signal name, password, encryption, and other parameters, recorded, as shown in the following figure

Record the wireless signal parameters that need to be relayed

Step two, set up the computer IP address

Before setting up the Tp-link tl-wr802n Mini router, you need to set the IP address of the wireless network card of the notebook computer to automatically obtain, as shown in the following figure. If not set, click Read: The computer dynamic IP address setting method.

XP system settings to automatically obtain IP address

Step three, connect to the TL-WR802N router wireless network

The computer searches for and connects to the 3G Mini router's signal (the router default SSID is: tp-link_xxxxxx (six digits behind the MAC address), which can be viewed to the MAC address on the router's bottom sticker.

Laptop wireless connection to tl-wr802n wireless network

Step four, log on to the TL-WR802N router Setup interface

1, open the computer desktop of IE browser, empty the address bar and enter 192.168.1.253 (admin address), return to the page will be pop-up login box. (192.168.1.1 can not open?) Read the article: Tp-link router 192.168.1.1 not open solution)

Enter 192.168.1.253 in Browser

2, in the "Set Password" box to set the management password, and in the "Confirm password" in the input again, click "OK".

Set the login password for the tl-wr802n router

PS: If you have previously set the login password, you will see the following image of the login box, enter the password to log in.

Enter the password you previously set

Note the problem: if the user forgets the login password previously set, the only solution is to restore the tl-wr802n router to the factory settings and reset the login password.

Step five, Relay amplification wireless signal settings

1. Run Setup Wizard

Click the "Setup Wizard"--> click "Next".

The Setup Wizard for the tl-wr802n router

2, the choice of wireless working mode

Select "Repeater relay Mode"--> click "Next".

Select "Repeater relay Mode" on the tl-wr802n router

3, Scan signal: Click "Scan"

Scans for wireless signals that need to be relayed

4, connect the main router signal

On the Scan page, locate the main router's SSID and click "Connect".

Connect to a wireless signal that needs to be amplified

Warm tip: If the scan does not have the corresponding signal (that is, the signal needs to be amplified), make sure that the main router has wireless enabled, and try to

Reduce the distance between routers.

5, enter the wireless password

Key type selection: Wpa/wpa2-Personal Edition (same as the key type of the amplified wireless signal)--> The password location:

6, the enlarged router's wireless password--> click "Next".

Fill in the password for the wireless signal that needs to be amplified

7, click "Reboot".

TL-WR802N Router Complete Setup

Step six, check that the settings are successful

After completing the appeal settings, the computer scans the wireless relay signal and determines that the signal strength has been enhanced to connect the wireless signal (in this case: Zhangsan) to the Internet.