At present, the network does not pass the main problems are:
1. Incorrect routing configuration
2. IP configuration Issues
3, Gateway Problems
4. Subnet mask problem
Can be based on the problem points listed above to troubleshoot.
One, routing problems:
Route print
Use the command above to view the routing settings, mainly focus on the permanent route of this section.
Route add-p 0.0.0.0 Mask 0.0.0.0 110.110.110.254
Use the command above to add a route.
Route Delete 0.0.0.0
Use the command above to remove the route.
Second, IP configuration issues
This requires attention to whether the IP address, gateway, subnet mask configuration are correct, and any one configuration error can cause the network to be out of line.
Recently encountered a subnet mask configured as a 255.255.0.0 problem, View Route Discovery Active route there is a corresponding xxx.xxx.0.0 route, resulting in the same network segment of the IP can access, but for the first two network segments the same, the third network segment different IP is unable to communicate, because the route is mistaken for the same network segment, took the wrong route.
This article is from the "composer" blog, make sure to keep this source http://zuoqujia.blog.51cto.com/9151800/1619676
Troubleshoot Windows network problems