Troubleshooting GTP Format Disk installation win7 system

Because the disk was made into a dynamic disk, causing the black screen cursor flashing after the boot, it seems that the partition is not found. So redo the system, but found that the disk deleted after the new. The solution is as follows:

2. At the point where the system prompts you not to install, hold down "SHIFT+F10" and Exhale the "cmd" command (if unresponsive, hold down "SHIFT+FN+F10" to try it)

4. Input: DiskPart, enter

   Into DiskPart.

6. Input: List disk, enter

   Display disk information

8. Input: Select disk 0, enter

   Select the No. 0 disk (the computer's hard drive number is 0)

10. Input: Clean, enter

    Delete disk Partitions & formatting

12. Input: Convert MBR, enter

    Set the current disk partition to MBR form

14. Input: Create partition primary size = XXX, enter

    Create primary partition size (MB)

16. Input: Format Fs=ntfs Quick, enter

    Format disk as NTFS

18. Input: Exit, enter

    Quit DiskPart

    Input: Exit, enter

    Exit cmd

Troubleshooting GTP Format Disk installation win7 system