Ultimate training for installing vrouters for China Netcom

The ultimate training for installing a vro for China Netcom is not very different from that for installing a vro for China Netcom. First look at the following address: http://asjn.ys168.com Yong Shuo hard disk has a single article size restrictions, so divided into three parts to upload, download, the three are downloaded, one of the three files must be downloaded, and the files must be downloaded to the same file.) There is a ShareGuard.exe file.

Just upload the file!

No more nonsense. Enter China Netcom router installation question: Let's take a look at how to link each device! Note the following points: the original method is that the connection between the cat and the route is through the port "5! 5. That port is what we often call the "WAN" port. Now we use any one of the "1-4" ports, it is often said that the "LAN" figure is a four-hole route, the cat occupies a port, and the remaining three links to three PCs.

If you have more machines. You can also use a vswitch, which is the same as before and occupies a PC port! Remember that the "5" port is an empty device link. Let's set up China Netcom to install the router. Our IP address is the IP address of the local machine, this shared Internet software must be installed on the network, so we will call it a server. Don't worry, the server is just a code, and it does not occupy much resources during running!

For server settings, set the IP address to: 192.168.XXX.XXX and later, my IP address is 192.168.1.8, The subnet is 255.255.255.0, And the gateway is empty. The following DNS will ask your network operator. After the configuration is complete, install the software mentioned at the beginning!

After the installation is started, run the "Setup Wizard" on the left, enter your ADSL Internet ID and password, complete the configuration, restart the software, and click Start service. This is what it looks like when it starts successfully. Okay, so far the local server has been configured. If other PCs are used, it is too easy. You just need to set up their IP addresses. No need to worry about installing vrouters in other China Netcom!

The IP address of other computers is configured as follows: the IP address is 192. 168. ×. 9 must be greater than the IP address set on the server. I set 8 just now, so this is 9, and the rest of the computers can go down, as long as it is greater than the IP address on the server, do not repeat it) the subnet is the same as the 255.255.255.0 gateway. Different from the server, the gateway must be set to 192.168.1.8, that is, the server IP address. The DNS and server are the same. Okay. After all, restart the software .... Haha. Is it all possible to go to the Internet? OK, you have succeeded!