Original
1, copy a layer, grinding skin, plug-ins or stamp grinding can be, with their own personal habits.
2, set up the color balance adjustment layer, the parameter sets the following figure. |
| 3, and then new optional color adjustment layer, the value is as follows. |
, then set up the curve adjustment layer, the parameters are set as shown below.
| 5, create hue/saturation adjustment layer, in order to remove the background of the cyan. This step is to choose red, yellow, magenta, blue with a straw suction on the background of the cyan, remove it, other methods can be. |
| 6, we found that the character eye band, the shoulder is not very beautiful, stamped a layer, decorated with the stamp tool. The finishing effect is as follows. |
7, another 50% of the gray layer, the pattern is soft light, with the deepening Dodge tool modification (this step modification to meticulous). Then stamped a layer, build a curve layer dot red, the steps are not given. Just a little mention.
8, the complexion is not bright enough, I added an optional color adjustment layer, the parameters are set as shown below. |
| 9, some places have been violent, then select the part of the violence, the method can be used quick mask, lasso, pens, to choose these places with curved surface, pay attention to excessive. The details are very important to finish the effect. |
| 10, the shoulder of the place is still not satisfied with the treatment, the method has been said, the effect: |
| 11, the color of the place is also a bit not very well, create an optional color adjustment layer, the parameter set the following figure: |
| 12, the color palette is over, some of the steps are wordy, but I am not sure I can do a satisfactory amount of time, the skill is not yet, do it again, it will not be so troublesome. The effect of color finish is as follows: |
13, create a blank layer, the pattern for color. Brush your favorite color around the eye, brush over the mask you can erase, rub the appropriate reduction of the brush than the transparency, the opacity of the layer, so that more natural, after the brush after copying a layer, the pattern to overlay, opacity 75%.
Duplicate a layer, the pattern for color Dodge, opacity 25%, my PSD screenshot and Effect diagram: (If you do not make my effect as I say, you can adjust it properly, there is no secret, is to reduce transparency, some layer mode, brush over, these I can not express in the language is very clear.) ) |
14, to create a blank layer, we give it a little "light powder", I do not know what to call it. The method is to use a quick mask to select the area around the eye, feather, and cancel the selection. The numbers are in their own hands, as long as they are too symmetrical.
Then add the black, perform the filter--noise--Add noise--Select the Gaussian distribution, the number of your own, and then change the layer mode to brighten, opacity 27%, and then copy a layer, pattern color reduction, opacity 22%. Add the mask, wipe the eyes out, because the eyes do not need light powder, the effect: |
| The final step, stamped layer, appropriate sharpening. Add material, text, finish the final effect: |
