Using Photoshop to pull out the beautiful pictures of bamboo groves sweet orange red

Original

< small map view big picture >

Final effect

1, open the original material, a new layer filled with reddish-brown: #793921, blending mode to "hue", the effect of the following figure. This step quickly turns the picture into a single red.

< map 1>

2, create curve adjustment layer, the blue adjustment, parameter settings such as Figure 2, the effect is shown in Figure 3. This step adds some yellow to the screen.

< map 2>

3. Press CTRL + ALT + + to pull up the high light selection, press CTRL + Shift + I to select a new layer to fill the dark cyan: #2F4F65, blending mode to "darken", opacity to: 50%, plus layer mask, with a black brush to wipe out the characters, the effect of the following figure. This step lowers the red concentration.

< map 4>

4, create a color balance adjustment layer, shadow, midtones, high light adjustment, parameter settings such as Figure 5-7, after the layer to determine the opacity: 60%, the effect of Figure 8. This step is to fine-tune the overall color.

< map 5>

< map 6>

< map 7>

5, and then create a color balance adjustment layer, shadow, midtones, high light adjustment, parameter settings such as Figure 9-11, to determine the layer opacity to: 30%, the effect is as Figure 12. This step adds dark cyan to the dark part of the screen.

< map 9>

< map 10>

< map 11>

6, create an optional color adjustment layer, red, yellow, white, black to adjust, parameter settings such as Figure 13-16, the effect is shown in Figure 17. This step enhances the red screen.

< map 13>

< map 14>

< map 15>

< map 16>

< map 17>

7, press CTRL + J to copy the current optional color adjustment layer, the opacity to: 50%, the effect of the following figure.

< map 18>

8, press CTRL + ALT + ~ To bring up the high light selection, press CTRL + Shift + I to select a new layer to fill the dark blue: #34203C, blending mode to "filter", the opacity to: 45%, the effect of the following figure.

< map 19>

9, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Simple to rub the skin of the characters, the general effect of the following figure.

< map 20>

10, a new layer, filled with orange, mixed mode to "filter Color", the opacity to: 50%, press and hold down the ALT key to add layer mask, with a white brush to the upper left corner of the section, the effect of the following figure.

< map 21>

11, a new layer, stamped layer. Execution: filter > Blur > Gaussian blur, the value is 5, after the layer blending mode is changed to "soft light", the opacity to: 30%, the effect of the following figure.

12, a new layer, stamped layer. Simple to the lower right corner of the picture with a dark angle, and then appropriately increase the brightness of the face, the general effect of the following figure.

< map 23>

Finally, fine-tune the details and colors to finish the final effect.

< small map view big picture >