Video card and CPU heat not good processing method
There are many graphics card fan is the following figure style, personal view, graphics card power is very large, fever is also very large, it is obvious that this type of just used nothing, because the basic full package structure, not much time, inside will accumulate a lot of ash, and not clean. The heat dissipation effect is needless to say more. The first step was to tear out the lance. Shell and fan as follows two figure
Find a Putong fan as shown in Figure 1 (this is a bit small for me, it can be appropriate to the larger point). Find a good position, put the screws in the nail fixed as shown in Fig. 2
The interface is as follows: The board is mostly 4 pins as shown in Figure 1. The common small fan interface is mostly three, as shown in Figure 2. Here, the card on the board is biased to the side and the small fan slot is the corresponding, this is the industry standard, the alignment of the good can be
In the example above can find a good point of the small fan, the new graphics card directly replaced, you can save a lot of heart. The same in the CPU fan and other graphics cards have a bad rotation caused by the restart, panic, and timely purchase of new replacements can also use this method, there is no way to use the screws fixed the case can be used to glue the two good first. Looks not very good-looking, but very practical! It's been a long time without worrying about this annoying and common problem of the fan turning bad.
This is to connect the power of the interface diagram, you can see the empty one, which is not affected by the use of this one is to measure the speed of the fan, mostly useless to