What is the CAD fill command?

What is the CAD fill command?

CAD Fill Command

Q: What is the CAD fill command? What is a CAD pattern fill shortcut key?

Answer: The CAD pattern fills the shortcut key is the h+ space bar.

The CAD fill shortcut keys are used in the following ways:

Enter H, and then press the SPACEBAR to perform the pattern fill command.

How the CAD pattern fill function is used:

Open the CAD interface, which is applicable to any version. We found the command to use according to the instructions in the following figure, in the Drawing toolbar. Look down the menu there's a "fill" command we're looking for.

CAD Fill Command

A dialog box appears, so let's take a look at the specific action. We see a lot of patterns on the left, and the right side is the setting for adding points.

CAD Fill Command

Understand the function area, see How to use it? Below I draw a simple diagram to show you: You see, I drew a square, this is a relatively simple situation, you can find inside any one of the patterns, let's fill it out.

CAD Fill Command

CAD Fill Command

The image above has already been populated. What you need to be aware of is that that proportion needs according to their needs to adjust the number of fill patterns, can be slowly adjusted, do not adjust the amplitude of a lot, it is easy to get the computer card death, because this display ratio is too small, the pattern will be very dense, very much of the computer memory. Let's take a look. And then we found the setting on the right with two boundaries:

CAD Fill Command

Let's take a look at their differences, and in what circumstances it would be more appropriate to use them, when we want to fill in the knowledge of a separate enclosed space, for example, a separate square on the image above, you can use the "Add Select Object" This setting, if you encounter the following figure, you need to use the "Add pickup point" this setting, Let's look at the diagram: