ZBrush How to use projection master to draw replacement details

The master of projection is a working mode, which can be depicted in 2.5D mode on 3D model after entering the model, and then picked up from canvas, this article will detail how to use projection master to draw the replacement details.

Before you draw: Be sure to make a large subdivision to the highest level before entering the master projection mode.

Step one, in the tool Control Panel, click the Load Tool button to load the tool. You can use the model you made yourself, or you can use the model provided by default ZBrush, hold down the left mouse button in the canvas, drag the pull out model, and press "T" to enter edit mode. Press SHIFT to make the model's side finish in a positive corner, and press the F key to maximize the center of the object.

Because the effect of drawing displacement details depends on the precision of the model, the subdivision level of the model is set to the highest when projected.

Step two, the mouse hover in the tool control group in the thumbnail view of the model information, due to the low number of grids, can not achieve better replacement effect, so continue to subdivide, activate Tool>geometry>divide, set the level of subdivision is the highest.

Tip: The projection master will be projected on anything in the grid object, so the location of the model is very important, make sure that the work area as far as possible to face the camera.

The following shows how to use the projection master to draw the replacement details of the model.

Step three, click the "Projection Master" button, pop-up projector master Settings panel, cancel the default open color options, check the "deformation deformation" button. When drawing the skin details of the model, you can activate the "normalized" option and the "Fade" option, and finally click the "DROP Now" button to peel the model off. At this point the model has been dropped off onto the canvas, and the model is plotted in detail below.

The model after the fall off will be converted to Pixols object fixed on the canvas, select the brush, set the stroke as "color Jet". Hold down the ALT key, click the Stroke thumbnail icon, adjust the stroke settings, open it on the right tray, adjust the stroke "displacement" and "flow" settings to enrich the brush effect. Select the appropriate alpha type according to your model's characteristics, and adjust the Z-strength setting to 5.

Step five, now you can draw the model's bump details, adjust the brush size, brush brushing the entire model.

Step six, after drawing finished, press the "G" key on the keyboard, pop the projector master's Setup Panel, check the "Double sided double-sided" option, so that the substitution effect you draw can be applied to both sides of the object at the same time. Click the "Pickup Now" button. Rotate the model, and you will find that both sides of the model are plotted with permutation details.