How to compile the Opus audio codec library for AndroidThe Opus audio codec library is the next generation of the Speex audio codec library. It has made great progress in terms of codec
Knowledge Point analysis:Microsoft UAA (Microsoft Universal Audio Architecture) bus driver is Microsoft's system-level support driver for HD Audio standard HD Audio bus (High Definition Audio. The new HD
and easy to process in real time.2. 1.1.2 what is G.711 encoding?A:G.711 suggests a typical compression codec method using PCM waveform encoding to achieve higher speech quality, but the data compression rate is low.G.711 it is recommended to describe the μ-law (A-Law) compression of PCM, as shown in:The sampling rate is 8 kHz, and the 12-bit linear A/D is transformed into A digital signal. After the logarithm PCM, the data is compressed to 8 bit, an
Originally did a very long time audio and video codec things, should do a summary. Here is about the audio and video coding This kind of work gains and losses and trade-offs, in fact, the main is to give up, there is no reason, right when a listen. Let the readers judge for themselves.Take video coding standard H., this is a good thing, after the standardization
Label: Use SP file code BS algorithm nbsp technology c
Video and Audio Encoding/decoding technology:
(1) silent FLC
(2) audio and visual Avi
(3) Both capacity and quality MPEG
The quality of MJPEG encoding is quite high. It is a kind of encoding with the highest quality requirement. It is a non-linear system.
Therefore, it tries its best to use the jitter algorithm during the Encoding Process (you can
.////////////////////////////////////////////////////////////////////////////
* * DAPM audio route definition.
*
defines an audio route originating at source via control and finishing
* at sink.
* *
struct Snd_soc_dapm_route {
const char *sink;
const char *control;
const char *source;
/* note:currently only supported for links where the source is a supply/
int (*connected) (struct
before recording the codec of your own learning audio, let's add a bit of hardware knowledgeA series of processors from the 8086 instruction set, known as the x86 processor, 8086 is the oldest 16-bit x86 processor, so the software is labeled I386, indicating that the software is 32-bit, based on the x86 processor , all 32-bit and 64-bit x86 processors can be run (unless the software is marked with a minimum
G.723.1 specifies a coded representation that can be used for compressing the speech or other audio signal component of multimedia services at a very low bit rate. in the design of this coder, the principal application considered was very low bit rate Visual Telephony as part of the overall H.324 family of standards.
G.723.1 has two bit rates associated with it. these are 5.3 and 6.3 kbit/s. the higher bit rate has greater quality. the lower bit rate
Audio codec and real-combat article (1) PCM go to AAC (AAC encoding)Author: Liu · Poechant Blog: blog.csdn.net/poechant e-mail: zhongchao.ustc@gmail.com Date: April 7th, 2012
This uses FAAC to implement AAC encoding. 1 Download and install FAAC
The installation process here is implemented on MAC and Linux, and windows can be similar to the reference.
wget http://downloads.sourceforge.net/faac/faac-1.28.tar.
Part of this article refers to the blog from Droidphone (http://blog.csdn.net/droidphone/article/details/6271122), about Alsa writing a very good article, just a few examples. This article is a combination of examples to analyze the ALSA audio driver.Development environment: ubuntu10.04Target board: linux-2.6.37 (view Linux kernel information via command uname-r)Compiler: arm-none-linux-gnueabi-(None on behalf of compiler creator, such as: FSL for Fre
As we mentioned in the previous section, ASOC is divided into machine, platform and codec, where the machine drive is responsible for coupling between platform and codec as well as parts and equipment or board-specific code, Again, refer to the previous section: The machine driver is responsible for handling some of the machine-specific controls and
DAPM and Dai widgets, the control parameters will be set later, and the function Snd_card_register of the registration card of ALSA will eventually be invoked.
ret = Snd_card_register (card->snd_card);
if (Ret
Summary: After machine-driven registrations, machine will be based on a platform device registered with "Soc_audio", and then in the driver's probe function of the platform with the same name, depending on the name in the Snd_soc_dai_link structure, Make a match to find the correspondin
channel, and two left and right audio channels, the bitstream is 1.411 Mbps, therefore, it is necessary to use a DMA controller for transmission. (For more information about audio DMA, see DMA on the wince platform)
(2) audio mixing
If you want the sound driver model of Windows CE to support sound mixing, consider the
User:
$ Su-
Step 2:
Change the running level to enter the character interface:
# Init 3
Step 3:
CD to the driver directory
./Ati-driver-installer-10-12-x86.x86_64.run # Run the Driver Installation Package
Follow the prompts
Step 4:
After the installation is complete, use shutdown-R now to restart the system.
No configuration is required. The video card can be
As we mentioned in the previous section, ASOC is divided into machine, Platform and codec, where the machine drive is responsible for coupling between Platform and codec as well as parts and equipment or board-specific code , Again, refer to the previous section: The machine driver is responsible for handling some of the machine-specific controls and
Compaq 511 series windows_xp driver chipset:Ftp://ftp.hp.com/pub/softpaq/sp36501-37000/sp36880.exeSound Card:Note: If you are installing Windows XP SP2, you must first install the "Microsoft universal audio architecture (uaa) bus driver ", if you are installing Windows XP SP3, you can directly install the Sound Card Driver
1. the role of the platform driver in ASOC has been described in the previous chapters. ASOC is divided into three parts: machine, platform, and CODEC. The main role of the platform driver is to manage audio data, finally, the audio data is transmitted to
System FrameworkPrinciple Description:Adopt distributed network system, install video client software on mobile phone, install camera Server software on remote server, collect camera real-time video, carry out H264 encoding, and publish it in the form of custom TCP server, and use the client software to enter the IP address of the server. Connect and watch live video.Feature Description:Currently learning version supports capture 320*240 video, server-side support boot and 3322 dynamic domain na
. The two-channel, also known as stereo, has two lines in the hardware, with better sound quality and timbre than mono, but the amount of storage space occupied by digitizing is one-fold more than mono.Second, sound card driverFor security reasons, applications under Linux cannot operate directly on a hardware device such as a sound card, but must pass through a kernel-supplied driver to complete it. The essence of
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.