hp 10g switch

When configuring the HP switch, connect to the Console line of Cisco directly at startup, with the default baud rate. However, the command line does not display anything, so I thought the machine was broken and I changed several, the baud rate has also changed a lot. I also asked a senior network engineer, later, when I tested the brocade switch, a customer asked

Dual-host switch (NewStartHA, SKYbility, hacmp, hp unix dual-host), hpux dual-host 1. Suse linux (NewStartHA ):# Cli Cli: ~>Service-migrate Select service to migrate: Current service: 0) bill 1) gdb 2) cancel Select a service [0, 2]: Enter the command line prompt for replacement. 2. AIX (HACMP ): # Smit hacmp Then enter: Switch the resource from suibao01 to suib

This article is from the original blog of Lao Niu. Address: Ghost This article is from the original blog address of Lao Niu:Http://www.cnpublic.com/2009/08/hpnotebook-Ubuntu-wlan-led/Reprinted please note Today, I used my Hp notebook to wirelessly access the internet. I found a strange problem, that is, the wireless Nic switch at the Palm has been flashing after network connectivity, and it is red when it

1. Configure www.2cto.com for the HP Server1. Start> Control Panel> HP Network 2. Select two NICs and click Team3. Click Properties 4. Start with switch 5. Server Load balancer, select Auto www.2cto.com 2. Configure the H3C switch www.2cto.com[DeviceA] vlan 10[DeviceA-vlan10] port gigabitEthernet 1/0/1[DeviceA-vlan10]

Specific steps to execute the factory default reset on the switch are:1. Using a small, thin tool with blunt ends (such as a paper clip), simultaneously press both the Reset and Clear buttons on The front of the switch.2. Continue to press the Clear button while releasing the Reset button.3. When all three Mode LEDs (ACT, FDx, and SPD) begin to Blink, release the Clear button. The

Earlier Ethernet switches used the architecture of Gigabit Ethernet switches, but added the 10GE module to support 10 Gbit/s Ethernet. We once made a 10G Ethernet topic named "10g power" in a newspaper in October 13. Many manufacturers mentioned that the early 10G Ethernet products only reached half of the throughput specified in the standard, and some of them pr

[Oracle @ node1 pfile] $ export ORACLE_SID = MRAC1 [Oracle @ node1 pfile] $ sqlplus/as sysdba SQL * Plus: Release 10.2.0.1.0-Production on Thu Sep 27 10:27:35 2012 Copyright (c) 1982,200 5, Oracle. All rights reserved. Oracle Database 10g Enterprise Edition Release 10.2.0.1.0-Production With the Partitioning, Real Application Clusters, OLAP and Data Mining options SQL> alter system set log_archive_dest_1 = '+ archlog' scope = both; Alter system set