ibm fc switch

relatively easy, as long as the controller is removed, replace the SAS module can be, the upgrade will not affect the data (this is not absolute), so the upgrade is very difficult. And clearly can supply all the original new accessories.After the above pre-work, this upgrade is also clear for the first to carry out the storage architecture upgrade to the FC San architecture, the use of redundant form, each server dual

The FC storage switch has a lot to learn about. Here we mainly introduce the partition and LIP isolation of the FC storage switch. In earlier SAN solutions, most servers were the same operating system, and the security issues in the SAN environment were not prominent. However, in the current scheme, the coexistence of

CISCO mds FC optical fiber switch configuration reference(1) There are several concepts that must be clarified (different from brocade ):(1) brocade divides zones directly. While mds divides zones under vsan, mds can divide several vsan first, and each vsan includes several zones.(2) brocase: the default port is open, while the default port of mds is closed.(3) mds has a Default zone: "The Default Zone ". i

Document directory 1. command syntax 2 zone configuration instance Technorati labels: Dell, switch, Zone Dell FC switch zone Configuration1 command syntax 1.1 login to switch Telnet IP Fabric OS (top_sw) Fabos version 5.2.2 Top_sw login: Admin Password: Top_sw: Admin>1.2 view help and all commands Help, view all co

Steps:1. Run first, porterrshow view port status, then ' Statsclear ' and ' slotstatsclear '2. View: Porterrshow, look at the port.3. Collection of Supportshow, Supportsave4. View Sfpshow-all can see the second-to-last line of 23 Rx power status, if larger is normalSfpshow-all:=============Port 0:=============Identifier:3 SFPConnector:7 LCtransceiver:540c402000000000 200,400,800_mb/s m5,m6 SW inter_distEncoding:1 8B10BBaud rate:85 (Units Megabaud)Length 9u:0 (units km)Length 9u:0 (Units-meters)L

, 7" Alicreate "sdb1", "1, 12" Alicreate "sdb2", "1, 13" Alicreate "ddm1", "1,14" Alicreate "jms1", "1, 15" Then create the name of the zone and the name of the included device (alicreate ): Zonecreate "arc0_4"; "cx6001, cx6002, l180, arc0" Zonecreate "sdb1_4"; "cx6001, cx6002, l180, sdb1" Zonecreate "sdb2_4"; "cx6001, cx6002, l180, sdb2" Zonecreate "ddm1_4"; "cx6001, cx6002, l180, ddm1" Zonecreate "jms1_4"; "cx6001, cx6002, l180, jms1" After that, create the cfg name and the included zone: Expo