thinkpad bios key

Lenovo's ThinkPad series notebooks are generally press F1 into the BIOS, but since most of the Lenovo notebook is pre-installed win 8 or higher version of the system, so sometimes there is no way to directly press F1 into the BIOS. The reason is because the fast boot setting is enabled in the win 8 or later system, which is because the system is booting too fast,

Failure phenomenon: after the machine closed to sleep and then wake up, found the mouse on the AC icon, the lower right corner of the battery status show "connected, not charging" as shown in the following image: But the actual battery can be charged normally, with a mouse click or wait for 1-2 minutes, again to see the battery status shown normal, as shown in the following figure: Impact Models: ThinkPad E440, E540Impact System: Microsoft Win

After shutdown is used this afternoon, the BIOS cannot be entered at night, and it has been stopped at press thinkvantage..., so the BIOS cannot be accessed. After restarting (Force Shutdown), press the blue thinkvantage key or F1, F2, F11, and F12. The solution is to unplug all USB cables, including the mouse and turn off the wireless connection. As a result, th

Lenovo ThinkPad E420 installed SSD to the CD-ROM drive bit, the BIOS can not find, PE to find SSD. Download old peaches PE version installed to U disk, start with U disk, enter WinPE, install system to SSD hard drive, reboot, BIOS can't find SSD hard drive, so will not start SSD system, only start original mechanical hard drive system. Run the PE built-in boo

First, f1~f12 restore normal buttonLenovo ThinkPad's f1~f12 key function is the opposite of other notebooks!In other words, if you do not press FN, press the function keys, the implementation is the function of the property settings, such as directly pressing the F1 key is mute, the F2 key is the volume down, F3 is the volume increase and so on. If you press the

First, f1~f12 restore normal button Lenovo ThinkPad E450 's F1~F12 key function is the opposite of other notebooks. In other words, if you do not press FN, in the several function keys, the implementation is the function of the property settings, such as directly pressing the F1 key is mute, the F2 key is the volume

1, boot, press F1 into the BIOS, select Config--keyboard/mouse,2. In the change to "f1-f12 keys" option, the changes are set to legacy or default.? ? (where legacy mode means you can use the hotkey without holding down the FN key.)? ? The default mode indicates that you need to hold down the FN key when using a hotkey, and then press the corresponding function

I just started ThinkPad l440. It's quite good to use. Hey, hey! The l440 system default (F1-F12) keyboard is the system default function key, mainly controls the volume, brightness, connection projector and so on. Because programming requires debugging, frequent use of F10, F11 and other keys, but by default these keys are system function keys, to press FN + (F1-F12) ke