access linksys router settings

address through a sub-routed DHCP server and cannot access the InternetEven if it is turned on, the IP address assigned by the default DHCP server for the secondary route only applies to the Internet through the sub-routed WAN port, so this IP address cannot be connected to the Internet through the main routed Wan port, which is an invalid IP addressSo we need to modify the DHCP server settings of the sub-

Router WAN Port set broadband dial-up Internet access, the Internet settings have been displayed in the upper right corner (is connected), but can not connect successfully, the following figure: Please refer to the following steps for troubleshooting. Broadband Line (household network cable or from "cat" out of th

address 211.90.137.25 255.255.255.252 ip nat outside exit: Set the ip address of the WAN port and set it as the port connecting to the external network.) ip route 0.0.0.0 0.0.0.0 211.90.137.26 sets a dynamic route) access-list 2 permit 192.168.0.1 0.0 . 0.255 create an access control list )! Dynamic NAT! Ip nat inside source list 2 pool c2610 overload create dynamic address translation) line console 0 exec

public IP address, but this translation only happens when the local IP address is sent to access a specific IP address and the specific service Web/FTP.4. NAPT Rule: the default factory settings of the system. This setting translates the reserved IP address and port of the local network into a single IP address of the public network and the port specified in the NAT global configuration. This method provid

routers are almost the same, and even some devices do not set the background logon password when leaving the factory, which is obviously very dangerous, if the password is improperly set, once the illegal neighbor enters the wireless router setting background management interface, they may set the local network parameters at will. In this case, open the IE browser of the local workstation and enter the default IP address of the wireless

wireless router configuration interface, the system will automatically pop up a "setting wizard ". In the setup wizard, only WAN port settings are provided. We recommend that you ignore the "setting wizard" and directly go to the "Network parameter settings" option. Network parameter settings In the network parameter

E-mapreduce has been fascinated by eMule in recent days. However, when I access the Internet through a vro at home, I always get a lowid and the speed is low. Verycd website is introduced to some of the NAT method (http://www.emule.org.cn/topic/nat/), But I zonet Broadband Router (ZSR-0104) with a lot of people, didn't say in it, had to try it, the success was finally achieved, roughly the same as the port

settings. now to the System Status tab in the "System Information" to see the status of the network, at the WAN end can be clearly seen ADSL dial-up access to information. After setting up the ADSL account, we can access the Internet through the broadband router, but in order to better manage and improve security, w

Dhcp:DHCP enable enable DHCP functionalityDHCP server FORBIDDEN-IP 192.168.1.1 Setting this IP does not participate in automatic assignmentDHCP server Ip-pool 0 defines a pool of addresses named 0Network 192.168.1.0 Mask 255.255.255.0 set the IP address range to be assigned automaticallyGateway-list 192.168.1.1 Set the gateway address for automatic acquisition of IPDns-list 222.74.1.200 set the automatically obtained DNS address to 222.74.1.200 (DNS based on the actual address

status. On the WAN side, you can clearly see the network information obtained by ADSL dialing. After configuring the ADSL account, we can access the Internet through the Broadband Router. However, to better manage and improve security, you need to perform the following operations: click the "Homepage" tab, select "DHCP" on the left, and set the ip address range of the