1. Click "Start" in the lower-left corner and select "Control Panel":
2. After opening the control panel, select "Sound":
3. Click "Record" in the new window shown in the following illustration:
4. You can see the "microphone" default device in the recording, as shown in the following figure:
5. Right-click on "Microphone" and select "Properties":
6. Click "Level", then slide "
This tutorial is the interaction of flash and microphone. Hopefully, you'll get better inspiration by learning this microphone interactive tutorial.
First look at this example, click Allow[Allow] and make a sound with the microphone, the effect is as follows:
OK, here we will step by step to achieve the above flash function:1. Turn on flash and create a new 30
and the other fills with black.
11 Moves the black rectangle 1 pixels to the right, and the white rectangle moves 1 pixels to the left.
12 repeat 9-11 steps until the effect is shown below.
13 to create a new layer head, will have moved to the group head.
14 Create a new layer on the layer head, select the rectangle, and fill it with the gradient effect set up in part eighth.
15 Press CTRL + T to perform the free transform to deform the right side of the rectangle as shown below:
16 Perfor
recording source where we select the microphone: MediaRecorder.AudioSource.MIC. Samplerateinhz The default sampling frequency, in Hertz, the official document says 44100 is compatible with all current devices, but if you test with a simulator, there are problems, so some 8000. Channelconfig, describes the audio channel settings Channel_in_mono guaranteed to work on all devices. Audioformat Audio stream format, divided into 16bit or 8bit is currently
1. Here we first try to connect the microphone to the front panel, and then use the system with the audio to debug, specifically, we click on the computer in the lower right corner of the audio icon, and then the pop-up menu in the corresponding menu should be detailed as shown in the following figure.
2. Now we go to the "main volume" panel, at home we see if there is no mute option, if we have to cancel, and I also have the
1. Find a piece of double-sided plastic, we have to make a bar, which is banded2. Put the double-sided adhesive on the microphone or speaker, and then smooth it out3. The double-sided adhesive will be torn off you will find a lot of dust, I repeated this operation, and then change the tape, directly without the ash so far4. Finish the call5. Note To clean up the dust do not take sharp objects to poke the microphon
To the users of the illustrator software for detailed parsing and sharing a tutorial on drawing an abstract microphone icon.
Tutorial Sharing:
1, open the AI to create a new 1600*1600px file, in fact, AI is a vector map, such as the new size of the file is not related.
2, select Rounded Rectangle tool, such as figure set. Here is a tip: when you draw a rounded rectangle, press the arrow key to increase the radius of the rounded rectangle
When the user is using the computer to record, the microphone and the sound card connection are normal, but cannot carry on the recording. Now the integrated sound card is generally a full-duplex sound card, the recording part of the problem is very little chance. You can try to resolve them by following these steps.
1. Determine if the sound card driver is normal
In the first step, right-click My Computer, select Properties, and open System propert
1. In the online music page that we clicked after we opened the microphone on the phone, choose a song that you want to hear.
2, enter the song open to enter after we click on More button effect as shown below
3, in more interfaces, the selection is set to the color ring as shown below
4, here will be prompted to the ring tone function only mobile number users can use, click immediately bind, and then bind your mobile number can
Last week, I sent an article asking for help.Article(Http://www.cnblogs.com/Sonne/archive/2007/07/23/828797.html). It seems that the problem has not been solved. Last night I finally found the problem and solved the stubborn problem.
The problem lies in the driver: in fact, my sound card driver has never been installed, but because I useWindows XPSystem, the built-in "driver" of the system can make the sound. before using the headset, I naturally do not know this. Because of this, in
1. Right-click the small speaker icon in the lower right corner of the screen and select [recording device ].2. The "microphone" default device is displayed in the recording, as shown in the following figure.3. Right-click "microphone" and select "properties ].4. Click level ].5. Slide the microphone slider to the left and right, adjust t
1, right click on "This computer" choose "Management";
2, left click "Device Manager";
3, on the right to find "image equipment" and point to open, choose "Camera" (different brands of notebook naming a slightly different, but all wrapped up "camera" word) Right click Select Disable. can disable the camera;
4, find "audio input and output" left-click, select the microphone right click to disable the selection.
W
how to tone the microphone mixer
1, before running the software to verify that the local computer's sound card and microphone can be used normally.
Run the software, and the model of the sound card and microphone is listed on the right side of the software. Open QQ and chat with friends, click the "Start" button to open the reverb effect.
2, in t
The location of the computer microphone interface can generally be found as follows:
Notebook computer: Generally in the left and right side of the computer to find the microphone/headset audio interface, the current Lenovo sold notebook computer, microphone/headset audio interface has the following two ways:
Mode one:
Mode two:
One machine
1. Of course, first of all we have to make sure that our external devices, hardware devices, that is, our microphone itself is good, if it is because the microphone itself is broken and the fault, then need to replace a microphone.
2. If it is not a microphone failure, we click on the Win7 flagship computer to
If you solve this two software conflict problem, you can temporarily solve the problem of the microphone is not sound ~
The biggest reason is that its sound card does not support the microphone and headset (stereo) direct connection function.
The direct-attached features are set out below:
How to set up ①xp and Vista
A) You can open the Control Panel-> sound and Audio Devices-> Volume-> advanced, or dir
When using the recording function, we can improve the recording effect by adjusting the microphone volume. The operation method is as follows:1. In desktop mode, locate the "speaker" icon in the lower right, as shown in the following illustration:2. Use the right mouse button to click the speaker icon and select Recording device.3. At this point, you can see the microphone device under the recording interfa
1. Of course, first of all we have to make sure that our external devices, hardware devices, that is, our microphone itself is good, if it is because the microphone itself is broken and the fault, then need to replace a microphone.
2. If it is not a microphone failure, we click on the Win7 flagship computer to open
Cool K Song Microphone no sound Solution
We mainly to solve the direct link function settings, please continue reading:
One, XP and Vista Setup method.
A) You can open the Control Panel-> sound and Audio Devices-> Volume-> advanced, or directly double-click the lower right corner of the desktop Volume control icon, open the Volume Control Panel.
(B) Clicking Properties in the Options menu opens the Properties panel:
or t
Many of our friends have recently been in love with the K-song on the Win7 system computer, directly on the Internet directly to sing, put a rhythm and then directly with our usual headphones microphone can be sung out, the sound inside directly can hear their own voice, like in the KTV singing, in fact, to achieve this effect is very simple , as long as we set it up, the way to enter the microphone voice s
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.