apple still sell iphone 6

Iphone6 How to connect the computer: 1 We first have to ensure that the latest version of the itunes software installed in the computer, (software can go to Baidu Search or Apple to download the latest version of itunes), after the installation of itunes, Apple mobile phone connected to the computer is no problem. 2 after installing the itunes software we just have to connect the iphone6 to the computer,

Cause analysis of automatic restart of Apple 6 Plus Automatic restart is mainly in the 128GB version of the iphone 6 Plus Other devices for the time being, and the authorities have not responded to the issue IPhone6 Plus infinite Restart solution This kind of problem is estimated to be more software installation o

Apple 6 cannot connect to the itunes Store solution:One: Network settingsUnder "Settings" found under "General" in the iOS desktop Find "restore network Settings" below find "restore" and then restart the iphone.Two: Reset Access restrictionsTry it in Apple 6. Find under "Settings" under "General" find "Access restrict

front of the "ring" tick, and then "OK" 9. You can see the "Bell" in the "database" to open the "Bell", you can see if your file has been turned into ringtones 10. Then in the "Device" open "iphone" select "Ringtones", in the "Sync Ringtones" item, select "All ringtones", or "select Ringtones", and then select "Sync", you can 11. The successful synchronization of the "ringtone" will appear in

IPhone6 error Code 53 The reason for the occurrence and resolution: 1, Apple 6/6plus Restore system error code 53 We can try to change a line of data to try, this may be the data line is not original or bad. 2, Touch ID is off the normal, this may be unable to verify the Touch ID caused. Correct brush Machine method:1. To Apple to download the latest ve

stackYou will still use the signals project in this chapter.In this chapter you will use a little of the knowledge of the assembly. Don't be afraid! But make sure that you're using the iphone 7 simulator in this chapter because the assembler code may be a little different if it's on iOS. This is because the real machine uses the ARM architecture, The simulator uses your Mac's local instruction set x86_64.Open the signals project in Xcode. Next, add a

Apple 6 activation Tutorial Share1. If you are a new machine, I first in the Iphone6 mobile phone Press the power button, boot about 20 seconds, the IPhone6 activation interface appears as shown in the following figure. 2. Now we turn on the computer and then connect the iphone6 to the computer and open itunes on the computer.3. Then itunes will pop up an interface we click "Update Settings".4. Then we cli