broadcom bluetooth driver

Yesterday, I looked at the introduction of Bluetooth protocol documents, today simply looked at the code in kernel (BlueZ), here to note, or inherited the old habits, Only focus on the overall process and ignore the details, first understand the approximate, and so on when the real need to carefully analyze. Net/hci_core.cThe main driver of HCI is to provide a unified interface for the upper layer, so that

http://blog.csdn.net/gotowu/article/details/46687633 1, the first to do BlueZ protocol stack transplant, so in the Development Board can be used Hciconfig, Hcitool and other commands. About the BlueZ protocol stack porting steps online a lot. 2, the drive is USB Bluetooth device driver, analysis according to the sequence of Bluetooth-driven write. Because only

effect of the I²c sensors task, you can see that the sensor controller has been able to read all the data that is of interest.The driver code in the IO sensors task is relatively simple and interesting to see the source code.~ ~ Finished, in fact, spent a lot of time to tune the drive, the main reason is the above mentioned HDC1000 cycle read the relationship, but finally is finally done.The source code of the project can be seen on the link below.Ht

Workaround: 1) Try to add the following CAB installation package: These packages basically include all the system files for the Bluetooth driver installation. Winemb-inf-bthmtpenum.cab Winemb-inf-bthpan.cab Winemb-inf-bthprint.cab Winemb-inf-bthspp.cab Winemb-networking-bluetooth.cab Winemb-inf-bth.cab Winemb-inf-hidbth.cab Winemb-inf-tdibth.cab 2 If the system has been pre-installed on the machin

1. Login to Samsung's official website www.samsung.com.cn, click on "After-sales service." 2. Select "Windows 8 Upgrade" at the bottom right of the page. 3. Click "Download SW UPDATE". 1. Click the right mouse button in the Metro interface space and select "All applications" in the lower right corner. 2. In "Application", click "SW Update". 3. The "SW Update" Software window opens, as shown in the following illustration: 1. In the upper-right corner of the software window, type "NP