Today's recommendation: cisco switch module Ethernet application details, familiar with the following cisco switch module knowledge point, you only need to spend a few minutes to understand the cisco switch Module Settings. There is also a diagram below, and other related information will be mentioned in this article.
As an important cisco switch modular multi-layer switch, the Catalyst 6500 series provides secure fusion services for cabling rooms, co
Understanding layer-3 Interfaces
Layer-3 interfaces are classified into two categories: Physical Layer-3 interfaces and logical layer-3 interfaces. logical layer-3 interfaces include layer-3 VLAN interfaces and routing sub-interfaces. layer-3 VLAN interfaces integrate the routing and bridging functions; the physical layer-3 interface has only the routing function, which is equivalent to a traditional router.
1. layer-3 logical VLAN Interface
The logical layer-3 VLAN interface provides a routing
adopted by investors.
Seven types of investment:
1. Common | slow growth refers to the company's income growth situation which is roughly the same as that of the overall economy. About 1%-9%.
2. Rapid growth: the company's annual revenue growth rate is above 10%.
3. Driven by specific time; it refers to the enterprise with high quality and undervalued values, preparing for complicated decomposition, financial restructuring, segmentation, or enterprise restructuring. These events may bring the v
Cisco 5000 ATMLANE MOUdle password recovery
Password Recovery Procedurefor the Catalyst 5000 atm lane Module
Description
This document describes the password recovery procedure for the Cisco Catalyst 5000 atm lan emulation (LANE) module(WS-X5153/5154/5155/5156/5157/5158/5166 ).Step-by-Step Procedure
In order to recover a password, you must download a recovery image onto the ATM module that will erase the
configuring the switch via the console port is the most common and basic management and configuration that network administrators must master.
The different types of switch console ports are located in the same location, some on the front panel (such as Catalyst 3200 and Catalyst 4006), and others on the back panel (such as Catalyst 1900 and
Some DHCP port settings are involved in this article. In its settings, Do you know some port problems? Configure the network environment of the DHCP server instance for a Cisco 3750 switch: A 3750 switch is divided into three VLANs. vlan2 is the network where the server is located, and the IP address segment is 192.168.2.0. The subnet mask is 255.255.255.0, gateway: 192.168.2.1. The Domain server is windows
Use Telnet to manage network devices
This management mode requires the configuration of commands on the routing and switching devices, which is less than the command configured in the SSH management mode. The following figure uses the topology of Figure 1 as an example to configure the vswitch so that you can manage the PC and use Telnet to manage the configuration of Cisco 4506.
The management VLAN 20 configuration on Cisco 4506 and Cisco 3750 is the
Failure phenomenon
When the computer is unable to connect to the Internet, find the user's IP address from the document, try to ping several, and find all the connections timed out. Then, Ping the Library building's central switch is normal.
The electronic reading Room uses Cisco Catalyst 2950t-24-smi as a hub device: and through a twisted pair of cables with the central switch of the library building Cisco Cata
This article is published by NetEase Cloud. Van Hin Xin (This article is only for internal sharing, if you need to reprint, please obtain the consent of the author authorization.) )Recently, big data-related technologies and traditional database technology are a lot of integration and mutual reference. The traditional database strength lies in its proven SQL optimizer experience, the weakness lies in the distributed field of high availability, fault tolerance, scalability, and so on, in time, l
The main function of Port-channel in practical work is to bundle two or more ports into a virtual channel.Interface Port-channel1Description Port (1/0/5-6)Switchport Trunk Encapsulation dot1qSwitchport Trunk allowed VLAN 10Switchport mode Trunk!Interface Port-channel2Description Port (1/0/7-8)Switchport Trunk Encapsulation dot1qSwitchport Trunk allowed VLAN 10Switchport mode Trunk!Interface Port-channel3Description Port (1/0/9-10)Switchport Trunk Encapsulation dot1qSwitchport Trunk allowed VLAN
Application examples
My school is a student apartment, PC owns about 1000 units. Using DHCP assigned IP address, with 4 C class addresses, the actual number of addresses available is about 1000. Because of the frequent presence of private DHCP servers in the building, a large number of hosts cannot be assigned to legitimate IP addresses, and because a significant number of hosts specify IP addresses, conflicts with DHCP-assigned IP addresses are caused. The above two aspects, all caused the apa
Vswitch Virtual Network (Virtual LANs) settings:
VLAN division and external VLAN routing settings on Catalyst 5000
Assign a VTP Domain)
Add Cat5000 to the domain
Specify the relay Port(A Trunk)
Dynamic ISL
Allocate VLAN to Port
Set VLAN 20
Configure the Router
Note: There are three VLANs, which are routed between VLANs through the Router.
-----------------------------------------------------------------
Allocate VTP Domains
What is VTP?
VTP is short f
Vswitch Virtual Network (Virtual LANs) settings:VLAN division and external VLAN routing settings on Catalyst 5000Assign a VTP Domain)Add Cat5000 to the domainSpecify the relay port (a Trunk)Dynamic ISLAllocate VLAN to PortSet VLAN 20Configure the RouterNote: There are three VLANs, which are routed between VLANs through the Router.-Allocate VTP DomainsWhat is VTP?VTP is short for VLAN Trunk Protocol. It provides each device (router or LAN-switch) to se
market ATI and nvidia two independent video cards occupy an absolute advantage, this period we will introduce the ATI video card driver installation settings.
ATI graphics driver features and installation
With the introduction of the "Catalyst (Catalyst) 2.1" drive, ATI has reversed its previous drive to update slow bugs and many other diseases. The driver has been able to do a one-month update to fix th
exceed-action drop
Policy-map output-policy-20m
Class Output-class
Police 20000000 1000000 exceed-action drop
Policy-map input-policy-20m
Class Input-class
Police 20000000 1000000 exceed-action drop
Interface fastethernet?/?
Service-policy input input-policy-5m
Service-policy Output output-policy-5m
Smart Ethernet Switch Series
The Cisco Catalyst 2960 Series Smart Ethernet switch is a new, fixed-configuration standalone device family that provides de
Use the serial port of your computer to manage network devices
Figure 7 front view of Cisco 3750
7 shows the front view of Cisco 3750. Generally, the electrical port and optical port of the switch are located on the front of the switch. This deployment facilitates the plugging of Network cables and optical cables on the device. The Console port for managing and configuring a vswitch is generally located
1. Download the Monitoring pluginwget http://nagios-snmp.cvs.sourceforge.net/nagios-snmp/plugins/check_snmp_int.pl2. First look at all the ports that the switch is currently openingFor i in ' seq 1 ';d o/usr/local/nagios/libexec/check_snmp_int.pl-h 192.168.0.254 -C PU Blic -N "^gigabitethernet1/0/$i $";d One3. Add Monitoring------------------------------------------------------------------------------------------Vim Hosts.cfgDefine host {Use Generic-switchHOST_NAME 3750m-portAlias 3750m-portAd
Application examples
My school is a student apartment, PC owns about 1000 units. Using DHCP assigned IP address, with 4 C class addresses, the actual number of addresses available is about 1000. Because of the frequent presence of private DHCP servers in the building, a large number of hosts cannot be assigned to legitimate IP addresses, and because a significant number of hosts specify IP addresses, conflicts with DHCP-assigned IP addresses are caused. The above two aspects, all caused the apar
Tags: call mode xxxx Virtual div package Data Packet Group EthernetThe main function of Port-channel in practical work is to bundle two or more ports into a virtual channel.Interface Port-channel1Description Port (1/0/5-6)Switchport Trunk Encapsulation dot1qSwitchport Trunk allowed VLAN 10Switchport mode Trunk!Interface Port-channel2Description Port (1/0/7-8)Switchport Trunk Encapsulation dot1qSwitchport Trunk allowed VLAN 10Switchport mode Trunk!Interface Port-channel3Description Port (1/0/9-10
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.