cisco linksys wireless g broadband router

Tp-link Wireless router's broadband speed limit function setting method 1, open the Tp-link Router Web management interface: In the Browse input 192.168.1.1 (Tp-link router default management address)---> enter username and password, the default is admin---> click "OK". (192.168.1.1 not open?) Click to read: Tp-link

Alpha AFW-GR50 Wireless Broadband Router is our life often used equipment, but how to evaluate the performance of a device? The following is a detailed explanation. Product testing: Tested by: Alpha RG50 Wireless Router The performance test mainly tests the AP throughput

It took me nearly half an hour. The original residential broadband is a pppoe dial-up connection. When the vro is set to start DHCP, it sets itself to 192.168.1.1. Generally, there is no problem. Today, broadband is migrated from Binjiang to Yuhang. The residential area is no longer in the pppoe mode, but in the dynamic IP Mode. After the wireless

The method steps are as follows: 1, first in the browser, open the router login address: 192.168.1.1, and then enter the administrator password login, as shown in the following figure. Note: Different brand router landing address may be different, if the 192.168.1.1 can not open, please check the router on the body nameplate, there will be annotations.

(Please prepare 2 short wire) (with ADSL Modem cat ) the telephone line (the relatively thin line) to pick up the cat lines (the relatively small mouth), the cat divided out A network cable to connect the router's WAN port (blue logo), and then find a short network cable, one to connect the computer, a router 1/2/3 any interface (yellow), wiring mode as follows: Note : when powered on, the

Currently, products that pass the Wi-Fi Protected Setup authentication can provide users with two implementation methods: · Push Button Configuration and PBC Configuration) · Input PIN code Pin Input Configuration, PIN) The following uses mercury MW150R and MW150U as examples: Configure WPS for the PBC: Press the WPS button on the MW150R front panel for about 2 seconds. Then the WPS indicator on the front panel of MW150R will be on. This indicates that the