cisco ntp server

An error is displayed when you use RHEL as an NTP server to update ntpdate on the server. My configuration is as follows: restrict127.0.0.1restrict-6: 1restrict10. Conflict An NTP server is built using RHEL. An error is displayed when ntpdate is updated on the

1. Select a server as the time synchronization server.2. Run regedit to open Registry Editor.3. Locate the registry key hkey_local_machine\system\currentcontrolset\services\w32time\config\, and in the right window, change the value of AnnounceFlags to 5.4. Continue to locate the registry key Hkey_local_machine\system\currentcontrolset\services\w32time\timeproviders\ntpserver\, In the right window, modify th

Tag:windows server serverntp @echo Offecho autor oak@echo offecho--------------------------------@echo offreg ADD hkey_local_machine\system\ currentcontrolset\services\w32time\parameters/v localntp/t reg_dword/d 00000001/f@echo OffREG ADD HKEY_LOCAL_MACHINE\system\currentcontrolset\services\w32time\timeproviders\ntpserver/v enabled/t reg_dword/d 00000001/f@echo OffREG ADD hkey_local_machine\system\currentcontrolset\services\w32time\config/v announcef

Experimental environment: Linux CentOS 5.5 Two units IP Address: ntpserver:192.168.186.129 ntpclient:192.168.186.152 Test requirements: Install the NTP server and deploy the implementation to allow the client to synchronize its practices normally. and analysis of the fault handling encountered during the implementation of the project. Implementation process: NtpServer-side deployments. 1, first che

Two ways to synchronize NTP: 1. Synchronize directly with the Ntpdate command 2. Smooth sync with NTPD serviceThe defect of the direct synchronization method: It will cause the scheduled task to be done again.The offset of the synchronization time of the smooth synchronization is not too steep, according to the offset, the mean variance equivalent of each synchronization a little bit, synchronization fully synchronized well takes a long time. So gener

use the UTC clock configuration file/etc/localtime the time profile on the local side, the timezone specified in the clock will be/usr/share/zoneinfo/Copy the time profile in the/etc/localtimeCommon directives:/bin/date for the modification and display of Linux software time/sbin/hwclock is used to modify and display the BIOS time, usually after modifying the system time with date, and then using Hwclock to synchronize to the BIOS./usr/sbin/ntpdate Client Time Correction tool/USR/SBIN/NTPD prov

First step to install NTPYum Install NTPSecond step, find the closest time synchronization serverHttp://www.pool.ntp.org/zone/asiaThe third edition of/etc/ntp.confServer 127.127.1.0 iburst # Local Clock when the external time server is unavailable, use the native time as the standard for the time serviceFudge 127.127.1.0 Stratum #这个值不能太高0-15, too high will be an errorFourth StepAdd an IP segment to allow accessRestrict 192.168.1.0 netmask 255.255.255.

quickly build NTP time synchronization server under LinuxBackground:server more, time consistency and readiness is particularly important, although this problem is always ignored, but the unification of time is very necessary, because the time problem caused by service problems is also commonplace, this article briefly introduce the rapid construction and use of NTP