cisco unmanaged switch 24 port

Port speed limit must start QoS on the switch Switch (config) #mls QoS//Start QoS on the switch Here are the implementation steps. First, create an ACL Since this is a three-layer switch, although the port speed limit, but also to

1. Catalyst 2900XL/3500XL/2950 series switch port monitoring configuration Run the following command to configure a port listener:Port monitorFor example, F0/1 and F0/2 belong to the same VLAN1 and F0/1 Listen to ports F0/2 and F0/2:Interface FastEthernet0/1Port monitor FastEthernet0/2Port monitor FastEthernet0/5Port monitor VLAN12. Configure

Introduction As the core network switch of our company, the CISCO3550 has been running stably for many years, and its functions can also meet our needs. However, its port speed limit function is not as easy to implement as some other switches, fortunately, the implementation method has been found recently. After the configuration is complete, it is verified with the iperf software. The result shows that thi

Catalyst 2900xl/3500xl/2950 Series switch Port listening configuration The following command configures Port sniffing: Port Monitor For example, F0/1 and F0/2, F0/2 are VLAN1,F0/1 listening F0/2, F0/2 ports: Interface FASTETHERNET0/1 Port Monitor FASTETHERNET0/2

switch>en switch#conf t//Enter global configuration mode Enter configuration commands, one per line. End With cntl/z. Switch (config) #monitor session 1 Source Interface Gigabitethernet 0/1 both//designated Port 0/1,both is in and out of the bag all caught Switch (config

Note: Each interface supports only one policy, and one policy can be used for multiple interfaces. Therefore, the download rate limit for the network segment under the port should be defined in the same policy 1. Start QoS on the switch Switch (config) #mls QoS//Start QoS on the switch 2. Define Access Control List