computer not seeing hard drive

attention to the configuration and performance of the motherboard, do not want to use the product of too old, then you can think of the method from the optical storage device. If you have two or more IDE hard drives that are used primarily for data backup, you can think of methods from the IDE interface. The implementation of the three major solutions, the next will give you a detailed introduction. Start with the motherboard: decisively discard th

Operation Steps: Hard disk is the most important computer equipment, it is like a large warehouse, which is stored in our most important data, it has the capacity of large speed and so on. We will daily life, learning important data files stored in the computer hard disk, but once the

1, hard drive data line and power cord loosening, oxidation or broken needle Workaround: Try swapping power connectors, data cables, or ide/sata interfaces. 2, may be some motherboards turned off the SATA interface, can not find the SATA hard drive Workaround: To open the SATA interface in the BIOS. 3, overclocking

1. Shift key Method This method has been used in Windows2000, right? It's like, anyway, I used this method when I turned off the CD automatically. When you insert a removable hard drive, hold down the SHIFT key and the hard drive will not play automatically. 2. Policy Group Closure method When panda incense is popul

Now many users in the configuration of a new computer, usually in the new computer at the same time installed two hard disk, that is, the mechanical hard disk +SSD solid-state drive, to store the corresponding data, and secondly can increase the speed of the system, set up o

MHDD is a Russian maysoft company produced professional hard disk tool software, with a lot of other hard disk tool software can not match the powerful features, now professional hard disk repair personnel with or MHDD this software, this shows MHDD powerful computer use for a long time,

I have installed the USB flash drive many times, but I cannot find the file. Finally, I found a blog to see how to install dual systems. Finally, I found that I could use hard disks for installation. After more than five hours, it was finally completed. ^-^. 1. The first is Partitioning. you can use the built-in Disk Management Program of Window7 to partition. (Ps I used CentOS to install the disc partition

the USB flash drive is connected to the computer and use another USB interface for testing. 2. Check the Device Manager to see if the "general bus device controller" entry exists. If not, enable the USB interface entry * in the BIOS of the computer motherboard ). 3. If other USB devices are installed on your computer,

When the hard drive is plugged into the computer, the LED is not lit and the USB interface and the interface line of the hard drive are observed, and the pins are not abnormal. Open the hard d