connect ide drive to sata

Install Linux on SATA hard disk (earlier versions)-General Linux technology-Linux technology and application information. For details, refer to the following section. You do not need to read the latest version. Sata hard drive In the BIOS of the motherboard, you must set the SATA mode from "enhancement" to the old

Introduction to Interfaces 　　IDE interface (Integrated-drive-electronics) is now commonly used external interface, mainly connected to the hard disk and optical drive. Using 16-bit data parallel transmission mode, small size, fast data transmission. An IDE interface can only receive two external devices.

If the serial hard disk is hooked up to the interface controlled by the onboard serial control chip, it is easier to set up. Take the P4C800 board PDC20378 serial control chip as an example, connect the serial hard disk and boot into the BIOS. Open the onboard serial controller switch in operating mode under the Advanced menu and set a good working mode. If set to IED, it will enter IDE mode after s

Recently I changed a new computer, and the company required to use the XP system for the project, but the blue screen is displayed every installation. Go to the Internet and check whether you want to change the hard disk mode in the BIOS to switch ahci to the IDE mode, and then install it. However, in the days to come, I found that it was difficult to handle the problem. I had to go to the network and check if I had to install the ahci driver, then I

LINUXSATA hard drive becomes IDE, and the speed is very slow-Linux general technology-Linux technology and application information. The following is a detailed description. The system IO is slow when you use a recycled dragon image. after re-installation, it was still very slow, but it was not the case with the system's Foxconn 945 motherboard. What happened was the 945 of Xiaojia. After comparison, we foun