connect to raspberry pi ssh

Tightvncserver onConfigure the Network1. Wired connection, and set static IP$ vi/etc/network/interfacesAuto LoIface Lo inet LoopbackAuto Eth0Allow-hotplug eth0Iface eth0 inet StaticAddress 192.168.1.120Gateway 192.168.1.1Netmask 255.255.255.0Auto Wlan0Allow-hotplug Wlan0Iface Wlan0 inet ManualWpa-conf/etc/wpa_supplicant/wpa_supplicant.conf$ Echo ' nameserver 114.114.114.114 ' >>/etc/resolv.conf2. Set up wireless (not successful)$ vi/etc/wpa_supplicant/wpa_supplicant.confCtrl_interface=/var/run/

Raspberry Pi brought a network port (eth0), I bought a edup 8188CUS Junk wireless network card (said it garbage because the default can not start the listening mode, to recompile the kernel, very frustrating)Eth0 Port I want it to connect to the Intranet 1 (192.168.2.0)Wlan1 Port I want it to connect to the Intranet 2

Reference: RPi Serial ConnectionThis article from: Http://www.raspberry-projects.com/pi/programming-in-c/uart-serial-port/using-the-uartUsing the UARTIf you is running Raspbian or similar then the UART would be used as a serial console. Using a suitable cable, such as the Ttl-232r-3v3-we, you can connect it to your PC and using some simple terminal software Set to 115200-8-n-1 use the command line interface

that the appropriate content is modified according to the actual situation: [Unit] Description=wireless Static IP Connectivity Wants=network.target Before=network.target [Service] Type=oneshot Remainafterexit=yes Environmentfile=/etc/conf.d/wifi EXECSTART=/SBIN/IP Link Set Dev wlan0 up EXECSTART=/SBIN/IP addr Add 192.168.34.1/24 broadcast 192.168.34.255 Dev Wlan0 EXECSTOP=/SBIN/IP addr Flush Dev Wlan0 EXECSTOP=/SBIN/IP Link Set Dev

1. Identify the internet cardWith the command LSUSB, you can continue down if you can identify it.2. Install the NIC driverThe Internet card will usually have 2 functions, one is a virtual CD-ROM, used to install the driver, and the other is a network connection modem.Under Linux, it is necessary to install the Usb-modeswitch driver to correctly identify and start the modem function of the NIC.sudo apt-get install Usb-modeswitch usb-modeswitch-data3. Install Dial-up softwareThere are many dialin

Raspberry Pi native Serial port default for console output, if you want to use in your own program need to shut down the system to occupy this serial port. The method is configured for Rasp-config, or directly modifies the/boot/cmdline.txt #dwc_otg. lpm_enable=0 console=tty1 console=serial0,115200 root=/dev/mmcblk0p2 rootfstype=ext4 elevator= Deadline Fsck.repair=yes Rootwai Dwc_otg.lpm_enable=0 console=tty

1. Format the SD card with Sdformatter2. Unzip the downloaded operating system3. Copy the operating system to the SD card (to be placed in the root directory, remove the outermost folder path)4. Insert the SD card into the Raspberry Pi and connect the power supply5. Select the system you want to install on the Start screen, then click InstallInstallation wait tim